Last Activity:11-25-2015 3:19 PM
Likes Given: 4
3 Likes on 3 Posts
Posted in thread: Chest Freezer to fit Speidel 60L Fermenter on 08-28-2015 at 02:39 PM
I went to measure the 5 cu ft GE chest freezer after reading that thread and I'm not sure how
it would fit (6 gallon fermenter would probably fit just fine though , just not the speidel). I
Posted in thread: Chest Freezer to fit Speidel 60L Fermenter on 08-28-2015 at 12:59 AM
I've been doing a little research on the same thing since I just bought a 5.1 cu ft chest
freezer in hopes of fitting a 6 or 12 gallon fermentor and found a thread where a poster says
that he fits 60L...
Posted in thread: Jaybird false bottom on 08-10-2015 at 01:52 AM
I have a 15" Jaybird FB with reverse hinges, Level 1 Filtration, hole drilled in the middle
that I've used twice and would be willing to sell. I thought I'd do more 10g batches in the
keggle, but have...
Posted in thread: 5 gallon cooler vs. 10 gallon cooler on 03-13-2015 at 12:06 AM
I've used both and found that a 10g cooler works fine for a 5g batch but here is a link to a
handy chart to help you with your decision.
Posted in thread: Homemade PBW Recipe on 03-01-2015 at 11:39 PM
Oxiclean is what a lot of users recommend, and if I could get away with it I would.
Unfortunately the water I use has a hardness over 400 ppm, and I need the chelator from the
detergent to bind to the...
Posted in thread: Visiting Orlando in May - Any Breweries Worth Visiting? on 02-22-2015 at 03:17 PM
If you are only able to find craft beer bars/ restaurants in downtown, look for Cigar City
beers. The brewery is located in Tampa but their beers are all over and you can't go wrong with
pretty much a...
Posted in thread: False bottom question on 01-04-2015 at 06:24 PM
Hey Bobby, do you offer the upgraded elbow connector and bulkhead for people like me who have
the cooler and domed false bottom already?I ditched the tiny elbow connector and just used cpvc
pipe with ...
Posted in thread: Temp controller on ebay on 06-28-2014 at 01:58 AM
I am planning on posting this weekend (but saw this thread) my Control Products temp controller
that I'm not going to use anymore since I got a Bev-Air Kegerator and just use the manual dial
to set te...
Posted in thread: RIMS where & how to measure temp on 04-25-2014 at 12:03 AM
A vacuum gauge seems like a really good idea. Thanks for posting that info, I'll be adding one
to my pump for sure!
Posted in thread: RIMS where & how to measure temp on 04-22-2014 at 04:50 PM
There are three places that it makes sense to me to put the sensor. In a tee just after the
wort leaves the keggle (what you mentioned above). In a tee just after your pump. Or in a tee
just before th...