kickflip_mj

Gift Premium Subscription To kickflip_mj

Join Date:

01-08-2008

Last Activity:

12-06-2016 1:21 AM

Likes Given: 17

109 Likes on 75 Posts 

LATEST ACTIVITY

  • Posted in thread: My insane 25 Gal, 100 Percent Hard Plumbed Tri-Clover, Automated Tippy Build on 04-12-2016 at 07:23 AM
    I have a source for the little ball valves. Looking for a source of pneumatic actuators that
    are reasonable to outfit onto triclamp butterflies. purchased the first 5 and they look great.
    For the pri...

  • Posted in thread: My insane 25 Gal, 100 Percent Hard Plumbed Tri-Clover, Automated Tippy Build on 04-11-2016 at 09:41 PM
    Are you looking for Pneumatic valves, or the little bal valves? Have you looked on ebay for the
    pneumatic valves?

  • Posted on ImObersteg Brewery in Brew Setup Registry on 03/29/2016

  • Posted in thread: How to remove mill scale from my stand? on 03-29-2016 at 07:32 AM
    Go to homedepot, and get these used them and polished my stand to almost a mirror finish, But
    I couldn't find high temp clear, so I painted it.

  • Posted in thread: Chugger pumps...impeller seizing? on 01-27-2016 at 12:32 AM
    The worst problem I've had is on my HLT, so it's only water.Yeah well 25 gallons of RO water
    that has been heating for an hour is a huge waste.

  • Posted in thread: Chugger pumps...impeller seizing? on 01-26-2016 at 10:12 PM
    Oh come on you guys! Did you see my post above? Don't turn off these pumps if they are handling
    high gravity wort (essentially every mash) or they will seize up due to the sugars collecting
    on the imp...

  • Posted in thread: Super Simple 15G Plastic Conical on 01-26-2016 at 08:51 PM
    The screws thread into the lip that is about the same thickness as the rest of the tank. Maybe
    1/16". the screws go well into the tank. The screws go through your applied silicone to
    hopefully seal th...

  • Posted in thread: Super Simple 15G Plastic Conical on 01-26-2016 at 07:54 PM
    I have a few questions maybe some one can please help answer.When they installed the threaded
    black lid with screws, did they drill all the way through so the screw goes into the tank? How
    deep is the...

  • Posted in thread: Chugger pumps...impeller seizing? on 01-26-2016 at 07:14 PM
    I have a mill and a lathe and even made new bearings on the impeller. Pretty much did
    everything you could possibly do on the impeller at this point, enlarged the bore, reduced the
    bore, adjusted axia...

  • Posted in thread: Replacement or alternate source for BrewTroller with volume sensing on 01-21-2016 at 07:39 PM
    See if you can figure out a pattern so we can fix it in the code. The pH part is really easy, a
    lot of those cheap pH meters put off an analog signal that would be very easy to read through
    the BT's a...

BREW SETUP REGISTRY ENTRIES:
  • ImObersteg Brewery
    ImObersteg Brewery
Following Stats
0 COMMENTS
POST A COMMENT