Last Activity:07-10-2014 9:48 AM
Likes Given: 2
5 Likes on 5 Posts
Posted in thread: Sam Adams Cold Snap Clone? on 06-25-2014 at 04:24 PM
To keep it simple could all spices be dry hopped? What % of munich malt are people using?Also,
how do you figure out how much spice to use.
Posted in thread: First all electric alls I can say is WOW! on 06-16-2014 at 07:31 PM
Boy you've been pushing your setup to the limits with the number of batches you've down. Good
to know its holding up.I posted on the PJ design thread, but wondering how I could use this
rheostat in co...
Posted in thread: First all electric alls I can say is WOW! on 06-16-2014 at 02:36 PM
So you went with this rheostat?: need to add one to my setup. I hear you on noise, so much
stealthier, not to mention more energy efficient and not having to worry about having enough
propane on bre...
Posted in thread: List of PJ Electrical Diagrams on 06-16-2014 at 02:29 PM
How does the rheostat work in that diagram? The ssvr is expecting 3-32vdc. The rheostat has no
power going to it, only a ground. Must be missing something.Also PJs diagram show the rheostat
Posted in thread: Beersmith 2 mobile: missing final ABV and efficiency? on 06-12-2014 at 07:35 PM
Glad you found it, those settings are burried a little deep but there.That's
interesting.....with all the other decent features, I cannot fathom why something as basic and
rudimentary as Efficiency an...
Posted in thread: Beersmith 2 mobile: missing final ABV and efficiency? on 06-11-2014 at 02:39 PM
Boy I hope I'm just missing these two things, because so far this app has been easy to use on
my android tablet. With all the other features, I would be surprised if the actual ABV and
Posted in thread: Can you leave elements submerged overnight? on 06-10-2014 at 02:57 PM
Check out this thread for a humorous read (it gets pretty heated): like the conclusion is a)
the water heater elements are protected by the ground back to the panel, b) most plumbing
systems have the...
Posted in thread: Can you leave elements submerged overnight? on 06-09-2014 at 01:13 PM
Oy vey. This sounds sketchy. Few things;- If you use stranded wire it will be easier to work
with, much more flexible. Based on your comment above you are/were using solid.- Fix the
problem (gfci trip...
Posted in thread: Rebuilding - Again... on 06-06-2014 at 09:45 PM
If anyones overwhelmed by the electrical side of things, here's the order I wired and tested
things;- Install the components in the box itself (ssr, contactor, etc.). When your doing the
Posted in thread: Rebuilding - Again... on 06-06-2014 at 12:32 PM
Probably shouldn't take an electrician too long to do, as long as he has a diagram. Most of the
effort is stripping wires, tidying them up, crimping connectors.You can do it with some basic