Last Activity:11-27-2015 6:46 AM
Likes Given: 4
Posted in thread: Kegerator Relay help on 11-22-2015 at 05:11 PM
Hmm.First, find a different appliance repair place.Most start relays are the push on type. They
may switch a capacitor in or simply connect the start winding to power.On small compressors,
they can be...
Posted in thread: Pale Ale on 05-16-2012 at 01:31 PM
I have the Garage Floor IPA full grain kit that I am starting in a couple of weeks. My first
brew.Someone else was asking about Hopdawgs a couple of days ago.I picked up my kit from Chris
Posted in thread: Help setting up 3 phase on 04-25-2012 at 07:37 PM
Unsure of the codes in Japan...In Canada, loading is 80%. 80% of 30 is 24A.You could probably
get away with 5kW elements. (200V * 25A = 5000W)A regular 5kW element rated at 208/240VAC would
work, but ...
Posted in thread: Building permits for a dedicated brewing room - hints? on 03-28-2012 at 02:00 PM
Kal,British Columbia experience here...At first glance, you may have problems with the quantity
of air you want to exhaust to the outside. Some jurisdictions require a dedicated, tempered
Posted in thread: Electronic part identification on 03-04-2012 at 09:27 PM
Likely a high limit. Contacts open and interrupt current flow at 185C (365F).Replace with
Klixon (Sensata) device or similar.Edit:OK, reading your post in detail, if you are sure that
it was wired *ac...
Posted in thread: PID Controller with Gas Valve on 03-03-2012 at 08:12 PM
If your PID has an analog output, like 4-20mA or 0-10VDC, you can do down the Maxitrol
route.The M4xx series valves are reasonable and then use a signal conditioner like an
SC11-B.This valve is not a ...