keithd

LATEST ACTIVITY

• Posted in thread: 1 PID Electric Brewery on 05-12-2012 at 03:11 AM
  Also, if you plan on using a rtd probe, I just asked for my pid to come already set for rtd in
  the comments section on the order page on auber website when I ordered. When I got it I just
  plugged it i...

• Posted in thread: sous vide on 05-12-2012 at 01:36 AM
  Here's my Coleman Xtreme 5-day 36 qt sous vide machine:The front: inside showing the aquarium
  pump and Loc-Line hose: the back: heating element is much like a RIMS system.I call it "The
  Viddilator"...

• Posted in thread: Yeti Coolers Better Than Coleman Ultra Extreme? on 04-12-2012 at 05:22 AM
  Maybe I'm not getting it, but why would you need such an expensive cooler for mashing?I use a
  Coleman Extreme 5-day, and I don't lose more than a single degree F over a 90 minute mash once
  temps are s...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-29-2011 at 05:28 AM
  Sorry for the slow response - I've been out. :oYes, I just use the pipe nipple threads to use
  as it's own thread tap. One thing I learned last night when building my second one - don't
  force it if it'...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-28-2011 at 03:37 AM
  16 gram CO2 cylinders.

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-27-2011 at 08:31 PM
  Glad to help! Let me know if there's anything unclear/confusing.This is just something I've
  been wanting to do ever since these threads about the Home Draft started showing up here.
  Unfortunately, I'm...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-27-2011 at 12:39 PM
  It holds pressure quite well as there's apparently a check valve somewhere beyond the tap's
  original regulator. I'd guess there's a valve similar to a football/basketball inflation valve.
  I didn't wan...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-27-2011 at 05:12 AM
  At this point, no further hacking on the tap is necessary. (*whew*)I went to Home Depot (other
  DIY stores should be just as good, it was closest) and got parts to connect an air chuck from
  the above p...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-27-2011 at 05:11 AM
  for the not-great pics, my Dad is kinda lacking in the camera dept., and I didn't think to
  bring my big guns.)So here is what we need to attack. There is a rubber grommet that surrounds
  the center p...

• Posted in thread: Miller / Coors Home Draft to regular or paintball CO2 on 01-27-2011 at 05:10 AM
  OK, here's the part we're going to attack: will need either a small precision flathead
  screwdriver or a sharp pick to remove the piece in the center. It's held on by two fingers, and
  I couldn't just ...