Last Activity:07-24-2014 11:32 AM
Likes Given: 3
2 Likes on 2 Posts
Posted in thread: Tweaking my IPA on 07-24-2014 at 06:02 PM
Try using some hop extract (CO2 Extract) for your next batch. I used hop extract in a Pliny
Clone I brewed in the spring and it turned out amazing. I went with the 100g cans from and
bought some bul...
Posted in thread: Raspberry Pints (Raspberry Pi) Users, What are you using as a display? on 04-02-2014 at 09:04 PM
I read that on the RPints website under "choosing a display". Somewhere in there it talks about
setting it up to run off USB from the pi but looks like it can't do both through USB only. So I
Posted in thread: Mitch's Electric Brewery Build on 04-02-2014 at 02:16 AM
Great job on the build. I just ran through my inbox and saw one of your old messages that led
me to this. You definitely don't need my crayola brutus wiring diagram anymore.
Posted in thread: Raspberry Pints (Raspberry Pi) Users, What are you using as a display? on 03-31-2014 at 05:10 PM
I just decided to tinker with a raspberry pi and started ordering what I need for a raspberry
pints draft list.What make/model/size monitor are you using and how many drafts are you
Posted in thread: 10 Jet Cast Iron Burners BRUTUS TEN build on 03-27-2014 at 06:27 PM
I finally got mine where Im happy with them but I had to use natural gas. I couldn't get them
to work with LP.I suspected you had the NG ones installed. I initially had the same issue...
Glad you got ...
Posted in thread: 10 Jet Cast Iron Burners BRUTUS TEN build on 03-27-2014 at 06:22 PM
On my first set of burners I drilled and tapped a hole to fit a small brass plug, in which i
painstakingly drilled tiny holes in to use as the pilot. As far as the fitting on the bottom,
I'd have to l...
Posted in thread: 10 Jet Cast Iron Burners BRUTUS TEN build on 03-04-2014 at 09:01 PM
I just measured and they're between 2.5" and just under 3" for my boil burner because there's
no asco on that one. Which burners do you have? I only get an orange flame if I have the valve
turned too ...
Posted in thread: 10 Jet Cast Iron Burners BRUTUS TEN build on 03-04-2014 at 07:39 PM
I'll have to measure them and get back to you, but if I were to guess they're close to around
3". If you're looking from the front, the tips of the burners are below the bottom of my top
support, if t...
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-27-2014 at 05:03 PM
Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-23-2014 at 04:06 PM
99 bottles of beer on the wall...