Last Activity:06-26-2015 4:20 PM
1 Likes on 1 Posts
Posted in thread: Motorized Mill Gear Motor Sources on 03-03-2015 at 08:50 PM
That would be perfect if it was half the price. All the "surplus" stuff is long gone eh??
Posted in thread: Motorized Mill Gear Motor Sources on 03-03-2015 at 08:07 PM
I have searched here and many other forums and I cannot seem to find a current source for a
gear motor that is suitable for a mill. Does anyone know where I can find one?? I would like to
get either a...
Posted in thread: HomeBrewTalk 2012 Big Giveaway on 02-07-2012 at 03:46 AM
Awesome!! Sign me up please!!!
Posted in thread: Finally, A Brewstand!! on 10-12-2011 at 09:00 PM
I think I may just add another horizontal run of stainless tube right below the top to hide
Posted in thread: BCS Control Panel on 10-12-2011 at 07:57 PM
THANK YOU!!!! That looks to be the perfect solution. Nice and clean too!!! In the shopping
basket it goes!!
Posted in thread: BCS Control Panel on 10-12-2011 at 06:27 PM
Those are helpful. I'll start reading. Do the 24v furnace gas valves need an SSR or with the
BCS do the switching??
Posted in thread: Finally, A Brewstand!! on 10-12-2011 at 04:58 PM
On a side note, where does everyone run the wiring for the pumps, and temp probes?? I would
imagine that the top rail would be to hot to run wire through for temp probes. The bottom would
Posted in thread: BCS Control Panel on 10-12-2011 at 04:56 PM
Now that I'm going on my stand ( I need to get the controls figured out. I searched and
searched and can't find what I'm looking for. Does anyone have a link to a thread or document
that shows how to...
Posted in thread: Jaybird's Stainless False Bottoms on 10-12-2011 at 02:12 PM
Jay,I'll get you the necessary measurements for the dip tubes and get with you shortly. Thanks
for the help.Jeremiah
Posted in thread: Finally, A Brewstand!! on 10-12-2011 at 01:34 AM
Finally got going on my brew stand. All stainless. Can't wait to wrap it up. It's all tacked
together now for the mockup. I'll weld it all together solid once I finish up the splash guard
for the pump...