Last Activity:09-27-2016 2:25 PM
Likes Given: 9
14 Likes on 14 Posts
Posted in thread: Intertap beer faucets on 09-29-2016 at 01:03 AM
funny you should say that about the perlicks being made in china... I ordered both a real
perlick off ebay and a chinese "perlick" off aliexpress and besides the cheaper chinese one
being made of stai...
Posted in thread: Examining possible solutions to issue of sulfur smell from Perlick 650ss faucets on 09-26-2016 at 08:03 PM
They should not, but I would still not let them sit with StarSan on them. BLC is preferred for
cleaning, and then rinse with clean water. While StarSan is advertized as a cleaner as well as
Posted in thread: Examining possible solutions to issue of sulfur smell from Perlick 650ss faucets on 09-26-2016 at 06:11 AM
so i ordered three chemicals, now after i do the cook. will my taps still emit sulfer if i run
starsan through them again or do i need to buy a new sanatizer?
Posted in thread: Examining possible solutions to issue of sulfur smell from Perlick 650ss faucets on 09-24-2016 at 02:13 AM
Just got 2 faucets and tossed them in starsan before installing them. Wow what a stink! Found
this thread when googling. I guess I'll have to try the passivation process, but I have to
order the stuff...
Posted in thread: Stretching Silicone tubing over 1/2" threaded camlock on 09-18-2016 at 06:17 AM
The tubing was easy to stretch over the fitting, I was surprised it was quickI can't find the
smooth clamps locally, are the regular hose clamps okay to use, as long as I dont over
Posted in thread: Intertap beer faucets on 09-17-2016 at 05:48 AM
My shanks are different Special for my towerThey screw into the tower itself and there's a
rubber oring on the end of them to seal where it meets the back of the sleeve in the tower So I
always have t...
Posted in thread: Intertap beer faucets on 09-16-2016 at 07:13 PM
Not sure we're talking about the same things... I'm talking about the nut INSIDE the tower, not
the bit on the outside that you screw the faucet into. If I don't have that really tight, the
Posted in thread: Intertap beer faucets on 09-16-2016 at 05:37 PM
I agree with jmarkI monster tightened them from the startI agree too, but after the splines get
rounded it won't matter, the splines are just not cut very well, but tightening the sh** out of
Posted in thread: Intertap beer faucets on 09-16-2016 at 04:46 PM
I replaced my FC Intertaps with my old non-FC Perlicks last night and didn't really see much
difference with the foaming on my big Tripel... There's air or CO2 getting in the line
somewhere and I real...
Posted in thread: Equinox Hops on 09-16-2016 at 06:01 AM
just got a lb of this stuff and was planning to do a single hop beer. not so sure it's a good
idea anymore after reading this.