- Posts 57
Last Activity:02-05-2016 6:50 PM
Likes Given: 6
Posted in thread: Crazy boiling after reaching setpoint on 01-14-2016 at 07:35 PM
My guess is that your controller is configured to vary the voltage of the signal going the SSR
(you described as controlling the "gain"). Therefore, if you set it at 50%, then it sends 50%
of the volt...
Posted in thread: Ss Brewtech’s Biggest Baddest Holiday Giveaway Ever! on 11-23-2015 at 06:25 PM
Count me in! Thanks.
Posted in thread: Keg Connection New Inline Flow Control Valve Giveaway on 10-05-2015 at 09:01 PM
Count me in! Thanks
Posted in thread: First time in 4 years garbage bag with spent grain broke lol - which bags are best? on 09-24-2015 at 07:16 PM
Trash compactor bags. They are a heavier gauge plastic to accommodate the compaction and
resulting heavier loads.
Posted in thread: HomeBrewSupply Amcyl Brew Kettle w/ 3-Piece Ball Valve Giveaway! on 07-29-2015 at 09:12 PM
Count me in!Thanks...Jon
Posted in thread: Coldbreak Brewing Herms Giveaway! on 07-16-2015 at 09:58 PM
Count me in! Thank you.Count me in!
Posted in thread: Chandler, Gilbert, Tempe, South Mesa Brewers? on 07-02-2015 at 09:31 PM
I'm also in Chandler (Chandler mall area). I'm just finishing up an eBIAB system which means
I'm not mobile for brew days so I'm not sure how that's going to work out. I'd be willing to
host a session...
Posted in thread: TeensyPi Networked Temperature Controller on 06-22-2015 at 04:08 PM
Sorry, just re-read your post and realized you were referring to the switches, not the temp
sensors. May I ask what you have connected to line 3? That pin is essentially the output of the
switch and s...
Posted in thread: TeensyPi Networked Temperature Controller on 06-22-2015 at 04:01 PM
Sounds like the sensors are only operating in parasitic mode? My first impression is it has to
be something in the connections. There should be one and only one resistor between the "Data"
and V+ line...
Posted in thread: TeensyPi Networked Temperature Controller on 06-09-2015 at 12:33 AM
Couldn't hurt! I'll try that tonight. My recollection is that the debug .ino was generated
before Jim put the debug code into the main .ino but, again, can't hurt.