VIEW MY

joutlaw

Gift Premium Subscription To joutlaw

Join Date:

07-19-2005

Last Activity:

03-11-2016 1:24 PM

Likes Given: 2

1 Likes on 1 Posts 

    ABOUT ME

  • Jackson, MS
  • Product Engineer
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: Question about 240v GFCI protection circuit on 10-23-2015 at 12:27 PM
    I was able to get everything hooked up. I had 3/4" conduit already run, but I was not able to
    fish another 6 gauge wire through it even with a sweeping 90 degree joint. So I took the
    conduit apart in ...

  • Posted in thread: Question about 240v GFCI protection circuit on 10-21-2015 at 07:48 PM
    i would go with a #6. i'd have to dig into the code book, you might be able to use a #8 but #6
    would be a best-practice.before pulling the neutral, try out your gfci and see if it operates
    without the...

  • Posted in thread: Question about 240v GFCI protection circuit on 10-21-2015 at 05:50 PM
    Should my neutral from the sub panel to the spa panel be 6 gauge copper like the 2 hot runs?
    Really wish I would have gotten the #6-4 at this point.

  • Posted in thread: Question about 240v GFCI protection circuit on 10-21-2015 at 05:17 PM
    the neutral and ground bars should only be bonded together at your main panel. any downstream
    sub panels, spa panels, receptacles, etc. all require separate neutrals and grounds.regarding
    the spa pane...

  • Posted in thread: Question about 240v GFCI protection circuit on 10-20-2015 at 06:21 PM
    I've never saw a thread get hijacked so many times in so few posts.My bad. Sorry OP. I just
    read the thread and seemed like we are facing a very similar issue.

  • Posted in thread: Question about 240v GFCI protection circuit on 10-20-2015 at 05:17 PM
    I have a hosehead controller with a 5500 watt element. I will add another hot pod that I can
    use between my HLT and BK eventually. Right now my setup is RIMS/propane hybrid.This panel will
    never requi...

  • Posted in thread: Question about 240v GFCI protection circuit on 10-20-2015 at 05:09 PM
    sounds like you have two hots and a ground wired to your receptacle. no problem there but
    recognize you won't be able to have any 120V loads, unless you put in a transformer. you do not
    need a neutral...

  • Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 05-27-2015 at 07:12 PM
    Looking for help...I've followed the diagram on the first page and have the temp probes
    working. However, I can not get the electrical outlet to actually switch on or off.I have a PC
    power cord that h...

  • Posted in thread: hosehead electronic brewery controller on 04-25-2015 at 04:23 AM
    Let us know how it goes. I'm seriously considering purchasing one and got a guy in our club
    interested as well. I think he has 6 day lead time so that could be the reason for the long
    ship times.

  • Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 03-31-2015 at 11:30 AM
    You aren't measuring current with that configuration, so "ma" isn't correct. You should be
    measuring volts, looking for a level approaching zero.If the LED is lit but the corresponding
    relay isn't lat...

FORUM SIGNATURE
Soon to be brewing again!
0 COMMENTS
POST A COMMENT