Last Activity:06-29-2015 2:24 PM
2 Likes on 2 Posts
Posted in thread: Brewie on 04-20-2015 at 01:24 PM
After watching the video it sure seems like this is following the Hot side process of a Brutus
20 (electric) using a BIAB bag (redundant? still early) instead of a false bottom. The
Air/Water heat exc...
Posted in thread: Utah Biodiesel Corny Keg Dry Hop Filter? on 04-15-2015 at 12:29 AM
I haven't had any issues. However I could see if the base got out of round that it would be
difficult to thread.
Posted in thread: Pump sizes? on 04-10-2015 at 03:30 PM
It's a small radiator thats a part of the HVAC system sits behind the dash of your car. The
model i used was a Spectra 94621 heater core. It cost $19.99.They were cheap, the right size
Posted in thread: Pump sizes? on 04-10-2015 at 01:22 AM
Fencdar,Just an idea for you, I'm using car heater cores that i picked up for ~$20 off of
amazon. I'm using 12v computer fans to move the air around and I'm able to get the individual
chambers down to...
Posted in thread: Corney Dry Hopping Options on 04-09-2015 at 08:28 PM
i have both the kettle hop strainer and the dry hoppers from Utah. I'm a fan of both for a
couple of reasons:1. stainless steel... 'nuf said..2. easy to do multiple dry hops without
dealing with leavi...
Posted in thread: The HomeBrewTalk 2015 Big Giveaway! on 04-09-2015 at 08:19 PM
Count me in. Thanks to the sponsors!
Posted in thread: 3 Chamber Fermentation Cabinet Build on 10-13-2014 at 02:21 AM
So i'm really catching up on what i've built over the last two weekends. Here's a preview of
what one of the chambers looks like with the mechanicals installed. Chamber fan on the left,
$20 heater cor...
Posted in thread: 3 Chamber Fermentation Cabinet Build on 10-13-2014 at 02:14 AM
Alrighty next step, trying to figure out how to insulate this thing. After looking around it
sure seemed like the 2" XPS foam was the way to go. A fresh blade in a razor knife, tape
measure and framin...
Posted in thread: 3 Chamber Fermentation Cabinet Build on 10-13-2014 at 02:07 AM
Alright, well getting underway is easy getting it done is the hard part. For the cabinet i'm a
huge fan of pocket hole screw construction. It's fast, strong and while not the cheapest thing
out there ...
Posted in thread: 3 Chamber Fermentation Cabinet Build on 10-13-2014 at 01:58 AM
Ok, So i'm tackling this build as three separate areas:1. Cabinet Construction: Building the
cabinet, loading it with insulation, getting it into place in the basement, etc.2. Plumbing:
Building the g...