VIEW MY

Jokenring

Gift Premium Subscription To Jokenring

Join Date:

04-14-2011

Last Activity:

04-12-2014 9:39 AM

    ABOUT ME

  • Male
  • Married
  • Bothell
  • Washington

LATEST ACTIVITY

  • Posted in thread: Brew Day Buzz Brewing on 09-11-2013 at 05:54 AM
    I typically enjoy a couple while brewing. I did however impose a time frame of no drinking
    until the boil for my brother. Seems he would not really clean things before putting them away,
    only for me t...

  • Posted in thread: Oktoberfest (1st place, scored 42) on 06-18-2013 at 12:38 AM
    Probably a dumb question. Are you doing the secondary fermentation after the 180 day lagering
    phase, or before?He would do that before. The 2 days at 70 is a diacytel rest.

  • Posted in thread: are my kegs ok? on 11-02-2012 at 08:55 PM
    Probably, you'll need to pressurize them with gas first to see if the seals are good. They will
    leak with no interior pressure forcing the gasket on the lid to the top of the keg.

  • Posted in thread: $800 1986 Nissan D21, should I? on 10-12-2012 at 06:54 PM
    It's deleted now :(

  • Posted in thread: Unveiling my brewery & garage build on 09-25-2012 at 05:54 PM
    As far as state goes, Foggy Noggin over in Bothell brews out of a detached garage at his
    residence. 192 brewing in Kenmore used to brew out of his 192 square foot shed, but he moved.
    Not sure on local...

  • Posted in thread: Unveiling my brewery & garage build on 09-20-2012 at 08:47 PM
    Just get some thin backerboard (the concrete stuff for tile work) screw that on then lay your
    stainless over that. Your current set-up may be fine, but why risk it. :mug:

  • Posted in thread: Keezer hinge help.. on 05-25-2012 at 09:33 PM
    This is what I was leaning towards but just wasn't sure if drilling there was ok.It'll be just
    fine.

  • Posted in thread: Keg urinal on 05-25-2012 at 09:03 PM
    Diamond Knot has one, but theirs is on it's side. Easier to use than those I would suspect.

  • Posted in thread: Keezer hinge help.. on 05-25-2012 at 03:25 AM
    Sink your first two screws (top), drill holes for two more below. Then screw away.

  • Posted in thread: What I've been up to... on 04-27-2012 at 06:36 PM
    I like where your mind is at.How is the Tell Tale? Haven't tried that one yet.

0 COMMENTS
POST A COMMENT