VIEW MY

joesmink

Gift Premium Subscription To joesmink

Join Date:

09-04-2013

Last Activity:

02-13-2016 1:29 AM

Likes Given: 8

9 Likes on 8 Posts 

    ABOUT ME

  • Male
  • Married
  • Stevensville
  • Ontario

LATEST ACTIVITY

  • Posted in thread: Advice on buying a new welder on 02-04-2016 at 07:39 PM
    first choice lincoln or miller second choice esab. Stick with 220v machine, maybe just a good
    quality MIG machine. MIG can weld steel aluminum and stainless with correct filler wires and
    gasses when y...

  • Posted in thread: Anyone dealt with smelly well water? on 02-04-2016 at 12:47 AM
    My Mother has water like that and we recently tried a little experiment with the water because
    it smells bad too.Put some water in a pitcher and leave it out overnight, the next day the
    water should b...

  • Posted in thread: Finally going to ask this on 02-04-2016 at 12:29 AM
    I live in Canada too, although Southern Ontario. I've got a Coleman Extreme cooler and only
    brew till late fall but heres a couple simple ideas for ya. Pre heat the cooler throw a gallon
    of boiling wa...

  • Posted in thread: Iglo Cooler Port on 12-30-2015 at 03:50 PM
    After I ran the tubing through the bung I shoved the clean and dry bung in from the inside
    really hardI've taken it out and put it back in several times with no difficulties or leaks etc

  • Posted in thread: Iglo Cooler Port on 12-29-2015 at 09:39 PM
    No sir no silicone nothinBung seals all on it own just like on a carboy sealed

  • Posted in thread: Iglo Cooler Port on 12-29-2015 at 06:36 PM
    Bung, tubing and plastic thingy that has adjustable flow, cheap enough for me:mug:A little soap
    on the tubing will get it to slide perfectly through hole in bung.

  • Posted in thread: Niagara Falls on 07-09-2015 at 09:48 PM
    Silversmith brewery in Virgil about 15 - 20 min from the fallsthey make their own beers and
    they're tasty too:mug:I've personally checked them out and would recommend a taste there:)

  • Posted in thread: Coil Heated Mash Tun on 03-15-2015 at 05:37 PM
    I built a coil in my cooler mash tun and recirculated water from my HLT through coil in cooler
    as well. I have found that raising temperature of grain bed is a slow process. Recirculating
    200 degree w...

  • Posted in thread: Any painters out there? on 11-04-2014 at 10:07 PM
    When you are going to spray them lay them out very close together and in the same orientation.
    Then when you spray from the sides the overspray is covering the next part. if all parts are
    laid out on ...

  • Posted in thread: Banjo Burner on LP propane problem on 11-03-2014 at 05:31 PM
    How about spider web inside air intake?Also discovered that wide open air intake not
    necessarily the best setting as it will vary with gas flow:mug:

0 COMMENTS
POST A COMMENT