Last Activity:03-31-2014 11:11 PM
1 Likes on 1 Posts
Posted in thread: March pumps not priming. on 08-27-2012 at 02:15 PM
I've seen these on a lot of setups... but wouldn't they leak wort? I'm designing a basement
eBrewery and just dumping wort on the ground is not an option for me.No, it's a valve.
Typically, you only n...
Posted in thread: March pumps not priming. on 08-26-2012 at 03:40 PM
One thing I have done is add priming valves to my outlets. This has greatly simplified the
effort to get things moving. When you are ready to start the pump, open the priming valve to
bleed any air ou...
Posted in thread: Keg Cowboy- Free Shipping!! on 12-02-2011 at 06:17 PM
are you still offering the coupons?
Posted in thread: More Burner Questions.... on 08-31-2011 at 07:01 PM
If they are the Chinese wok burner style, they are definitely low pressure. You will need a .5
psi regulator. The trick is to make sure every element from the tank to the burner is rated to
Posted in thread: 5% off Coupon - KegCowboy.Com on 08-31-2011 at 07:00 PM
Wrong board. Deleted
Posted in thread: Allen Bradley SLC 500 on 07-06-2011 at 12:28 PM
No, I am the programmer in the family. I am obliquely associated with the SCADA projects at my
company, and provide some of the support, so I am familiar with the programming theory. I may
get with my...
Posted in thread: Allen Bradley SLC 500 on 07-04-2011 at 02:57 PM
Yep, that is kind of what I am beginning to figure out. The controller does have a cat-5
interface built into the chassis, so I am pretty sure I can interface with the controller, but
I am not finding...
Posted in thread: Controller question on 07-04-2011 at 02:50 PM
No, you should be able to run a single PID. But I was just doing the math. If you are runining
110 Volt, you can get away with a single 40 amp SSR, but if you are running 220 Volt, you will
Posted in thread: Controller question on 07-04-2011 at 02:33 PM
That is what I would do. Or use a higher amperage SSR. Typically, I am using a 25 amp ssr to
control 1 element. But a 40 amp ssr should be able to handle 2, just do the math based on your
Posted in thread: Allen Bradley SLC 500 on 07-04-2011 at 02:01 PM
As I am looking at the 500 series documentation, it looks like I will need a separate module to
use my current RTD sensors.