jawbox

LATEST ACTIVITY

• Posted in thread: 110v Recirculating eBIAB 2.5 gallon batches on 02-03-2013 at 04:27 PM
  Finally finished wiring this guy up. Will do a water test this
  week.https://sphotos-b.xx.fbcdn.net/hphotos-ash3/602918_10151635476086102_2118098334_n.jpghttps
  ://sphotos-b.xx.fbcdn.net/hphotos-snc6/774...

• Posted in thread: RIMS for Dummies on 01-03-2013 at 03:14 AM
  PJ,I'm looking to make a portable rims tube setup similar to this and was wondering how would
  you change this if you were using the LED switches (similar to GCX3253-120L) from Automation
  Direct? I'm a...

• Posted in thread: Electric Question on 08-13-2011 at 02:52 AM
  How are you attaching the bcs and contactor to the din rail?

• Posted in thread: Electric Question on 08-10-2011 at 01:57 AM
  would this one work?Looks like i would be real close to pulling 40A so a little nervous about
  the 40A form auber.

• Posted in thread: Electric Question on 08-09-2011 at 03:34 AM
  Ed,What Contactor did you use??Thanks,Jaw

• Posted in thread: Electric Question on 08-06-2011 at 03:14 AM
  Ed,Couple of questions for you. 1) Looking at Automation Direct I see multiple curve breakers,
  Which Curve breakers are you using for the following on your diagram? a) Fast acting (B, C, D)?
  b) Delay ...

• Posted in thread: Need to Plumb my new Single Tier (Brutus 10 Style) ANY SUGGESTIONS? on 08-01-2009 at 02:55 AM
  Which STC valves are you using, and where did you get them?

• Posted in thread: Love Temp Controller Series TS wiring diagram (2008+) on 12-11-2008 at 12:34 AM
  wouldn't recommend using a jumper. I believe those terminals are for one wire only. You might
  be better to splice and run a pigtail to terminal 10.Hope you can see the picture ok.