Last Activity:09-04-2015 12:58 PM
1 Likes on 1 Posts
Posted in thread: How much wort should I collect? on 09-03-2015 at 11:13 PM
I'm new to all grain brewing and I have a question about the amount of wort that I should
collect after sparging. So far I've only brewed 3 all grain batches. The last two recipes said
to collect 8 ga...
Posted in thread: Another Grain Mill on 08-29-2015 at 02:46 AM
Yep, I used some scraps that I had laying around. I was going to use some old plywood, but the
piece was too big and did not want to waste it, It was a fun project. How does the crush look?
Not too fi...
Posted in thread: Grain hopper size??? on 08-25-2015 at 01:51 AM
Now that is good question...The top part of the hopper is 7.25"W x 11.25"L x 7.5"H = 611.7 cu
inches (all inside dimensions). Figuring out the volume of the bottom or funnel section of the
hopper is m...
Posted in thread: Another Grain Mill on 08-24-2015 at 08:07 PM
Below are pics of my my new MM3 and my homemade base and hopper. I made the base out of plywood
and hopper out of 3/4" pine. The hopper is made so it slides over the MM3 and doesn't need to
Posted in thread: Grain hopper size??? on 08-24-2015 at 07:55 PM
Well I've finished putting together the hopper and base for my new MM3 Grain mill. As promised
below is a couple pics. I made the hopper out of some pine and plywood that I had laying
around. The hopp...
Posted in thread: polyurethane finish opaint on 08-18-2015 at 02:29 AM
I'm confused, don't you crush your grains doing BIAB? I'm trying to figure out if i should
leave my grain mill hopper raw wood or put some kind of finish on it.Ps: sorry for the typos,
my tablet is ha...
Posted in thread: polyurethane finish or paint on my grain hopper?? on 08-18-2015 at 02:15 AM
I am making a hopper for my new MM3 grain mill out of pine and I'm wonering if I should put a
polyurethane finish on it, paint it or leave it raw? I thoght that it would be easier to keep
clean with s...
Posted in thread: polyurethane finish opaint on 08-18-2015 at 02:14 AM
I am making a hopper for my new MM3 grain mill out of pine and I'm wonering if I should or
shouldn't put polyurethane finish or paint on it? I thought that it would be easier to keep
clean with some s...
Posted in thread: Grain hopper size??? on 08-08-2015 at 02:12 PM
That is exactly what I was looking for!I'm planning to make my hopper out of wood and I found a
very interesting web page (https://jansson.us/jcompound.html) that helped me figure out the
Posted in thread: Grain hopper size??? on 08-05-2015 at 01:29 AM
I just purchased an MM3 grain mill and I'm about to build a hopper and basefor it, but I don't
know how large to make it. I'd like it to hold enough for a 5.5 gallon batch, say 13 - 14 lbs
of grain. D...