Last Activity:10-01-2016 4:55 AM
Likes Given: 1
19 Likes on 17 Posts
Posted in thread: HERMS coil mounting on 10-01-2016 at 01:45 AM
Did you put just one valve on it or two? Two seems excessive, but I've seen it before.
Posted in thread: Deep Six Brewing System - v2.0 on 09-29-2016 at 04:51 PM
I though the old system was a two vessel system. (May be confusing it with another brewery)What
made you go to three?
Posted in thread: HERMS coil mounting on 09-29-2016 at 05:25 AM
Ok, HERMS coil through the side of the HLT leaves no loose equipment banging around, and it's
easier to drain it when I'm done. Alternatively mounting it through the lid lets you use it as
Posted in thread: Deep Six Brewing System - v2.0 on 09-29-2016 at 03:22 AM
I remember you. I was sad when your brewery went for a swim. That control panel is amazing.
Posted in thread: DIY plate chiller idea on 09-28-2016 at 08:26 PM
This has crossed my mind a few times also. I've even contemplated just building it out of flat
plates instead of the corrugated ones the pros use. The seals certainly are the hardest part.
Posted in thread: Electric conversion on 09-28-2016 at 05:16 PM
You are correct. The alarm wouldn't function if desired if my circuit was modified to use
momentary action start switch.Brew on :mug:Yeah, I think I'll just have to figure out to go
look at my switche...
Posted in thread: Utility Cart BIAB setup ideas on 09-28-2016 at 09:47 AM
I've got a piece of poo push cart from harbor crap that I store my brewery gear on. I use it to
hold my HLT during brewing, and have the MLT and BK on burners in the ground. Switching over to
Posted in thread: Electric conversion on 09-28-2016 at 09:06 AM
Sorry, for some reason I got the impression you were going to use a maintained action start
switch.If you want to use a momentary action start switch, just move the branch connection on
the right of m...
Posted in thread: Electric conversion on 09-28-2016 at 06:26 AM
This circuit will work, but I don't see how it is any simpler than the one I provided that does
allow for the alarm you desire.Brew on :mug:I have a momentary button to energize the coil.
Yours has a ...
Posted in thread: Electric conversion on 09-28-2016 at 06:17 AM
Yes, EPO is Emergency Power Off. It is in the coil latch circuit. As shown, it will interrupt
all voltage supply to the interlock relay when it is activated, thus causing the latch to be