Gift Premium Subscription To infantej

Join Date:


Last Activity:

09-04-2014 3:35 PM


  • Michigan
  • Female
  • Single


  • Posted in thread: Wine Barrel Project on 07-17-2012 at 06:30 PM
    I have this same project going. I have a bourbon barrel going on two years and a wine barrel
    going on one. My advice is to pitch a blend because it is simply easier. You should also
    primary outside of...

  • Posted in thread: Opening a Brewery Licenses and Fees on 04-26-2012 at 02:04 AM
    Consult with an attorney, you're going to need to set up a corporation at the very least (LLC
    or Corp.)I ran a quick search at the Colorado Bar Association for lawyers specializing in
    business law, vi...

  • Posted in thread: NHC 2012 First Round Scoresheets on 04-25-2012 at 01:57 PM
    I sent in a Schwarzbier and a Porter.. neither placed.Congrats Osagedr on your silver and two
    bronze and good luck with your entry into the second round. :mug:How do you know you didn't
    place? From wh...

  • Posted in thread: NHC 2012 First Round Scoresheets on 04-24-2012 at 11:34 PM
    Minny scores are out. Got a 35 for a bourbon barrel flanders red in specialty category.
    Mini-bos was marked but no place indicated.

  • Posted in thread: NHC contest registration on 03-05-2012 at 01:50 PM
    Just a heads up. San Francisco dropped to 745 entries, so there's now 5 open spots there. If
    you don't pay in 24 hours your entries are cleared and it opens up spots for new entries. Keep
    refreshing t...

  • Posted in thread: Cheap & Easy 10 Gallon Rubbermaid MLT Conversion on 01-11-2012 at 02:17 PM
    One thing I did when I replaced my worn out braid was to add copper tubing to the inside of the
    braid. I just cut a couple of short pieces of copper with slits in them and fed them inside the
    braid. I...

  • Posted in thread: Weldless brew stand. on 01-09-2012 at 05:08 PM
    Does anyone have recommendations on a heatshield to go with the BG14 burners? I fired this up
    for the first time yesterday and didn't have my cement board properly placed and melted my
    polycarbonate s...

  • Posted in thread: Propane Lines for Brew Stand on 12-30-2011 at 10:11 PM
    I think we are talking about different things. where do I get the fittings in your picture that
    are attached to the burners?

  • Posted in thread: Propane Lines for Brew Stand on 12-30-2011 at 09:44 PM
    This is the size you want unless you use an adapter or a custom hose with different size
    ends.The cast iron burners use a 3/8" FIP fittingsOkay, but how do I connect to the burners?
    I'd prefer to not ...

  • Posted in thread: Propane Lines for Brew Stand on 12-30-2011 at 09:28 PM
    I'm looking for a little help on this as well. I have the black pipe and have it run back to my
    propane tanke. I picked up gas ball valves from lowes. Will those work? Also, I ordered my
    burners from ...