- Posts 18
Last Activity:12-27-2010 10:35 PM
Posted in thread: Project "WOODY 3.0XPR" worlds first wooden, adjustable, 3 roller grain mill on 03-30-2010 at 06:46 PM
So one question, did you leave the rollers with the flat surfaces, or was that prep for
lathing. I would think the more flat surfaces the better the crush. Do you know what your
roller gap is, if its ...
Posted in thread: Pneumatic Keezer on 03-30-2010 at 06:20 PM
Putting wood around the cooler is possible on the rear, but the other sides are where your
condenser is for cooling. My collar extends out the front 16", and the 'bar' is in the rear,
with wood decora...
Posted in thread: Pneumatic Keezer on 03-30-2010 at 06:04 PM
The idea for the taps inside the freezer came from the idea of if it could be made without
putting any holes in the freezer. I know this could be done using a collar. Although this will
be in a game r...
Posted in thread: Pneumatic Keezer on 03-30-2010 at 05:54 PM
Well lets look and see how this will likely be used. WHen you first come up with the great
creation it is so much fun to show your friends, but when practicality kicks in, My bet is that
it will sit o...
Posted in thread: Grain mill roller question on 03-30-2010 at 05:19 PM
I noticed the other day that some seat posts for bicycles are knurled. Could probably scrounge
a few behind a bike shop.... Personally I'm gonna go the pasta maker route. My wife gave me the
go ahead ...
Posted in thread: Grain mill roller question on 03-30-2010 at 05:16 PM
Seen a few homemade concrete mills and the results have been fine. One point not clearly
mentioned is the drive rod you put through should have some pins drilled or welded on leftover
hardware or such...
Posted in thread: Is this an infection? on 03-30-2010 at 03:59 PM
The dusty looking clumps of bubbles have the appearance of Brettanomyces. I have seen bubbles
6" around in some of my Lambics after about 6 months or so. If so, the characteristic leather
and horse bl...
Posted in thread: Off Smell Identified... Now How to Fix... on 03-30-2010 at 03:50 PM
Whens the last time you cleaned beer lines. Sounds like a beer line issue to me. First beer
tastes bad, then you get the line cleared and new beer from keg. Ive seen that on my system
when Im bad on l...
Posted in thread: Frigidaire Model FRC445GB Keg Conversion on 03-30-2010 at 03:29 PM
not the OP dont know if he is going to but in my tower I just have the lines running thru the
pipes no fan the copper conducts the cold up from the fridge into the tower and helps immensly.
with the f...
Posted in thread: Mill Speed? on 02-23-2010 at 04:34 PM
I'm looking forward to my 'footcrank' setup, when done."I may be totally wrong, but I'm a
.......brewin Foooo- eeeuuuuu-ooooooo- eouuuuuoooo-l"Footcrank. GREAT IDEA. Take an old
bicycle, mount the mil...