Huaco

Gift Premium Subscription To Huaco

Join Date:

12-05-2011

Last Activity:

04-28-2016 6:53 PM

Likes Given: 48

139 Likes on 87 Posts 

    ABOUT ME

  • SolidWorks Designer
  • Craig
  • Texas-Red dirt music
  • Shawshank Redemption
  • Breaking bad, walking dead
  • Cap and Hare, Fort Worth, TX
  • Male
  • Married
  • Just south of Cow Town
  • Tx

LATEST ACTIVITY

  • Posted in thread: Show us your sculpture or brew rig on 04-22-2016 at 09:07 PM
    Properly shielded burners, which those look to be, will keep the heat channeling up and out. I
    wanted to test this once and the carburetor plate portion of the big banjo burners doesn't even
    get hot t...

  • Posted in thread: How to add permanent volume markings to a kettle (illustrated) on 04-22-2016 at 05:09 PM
    You could also measure the water level by weight.That's what I did when calibrating my sight
    glass. I weighed out a gallon of water and marked it on the gallon jug with a sharpie. Then, as
    long as you...

  • Posted in thread: Low bucks motorized grain mill on 04-05-2016 at 07:19 PM
    Saving $0.50/pound on grain is just icing on the cake.Thanks for the update! Can you post the
    photos/video?WOAH! I worked at my LHBS, Texas Brewing Inc., for a while and we NEVER charged
    for milling o...

  • Posted in thread: Walkin Cooler TX Build on 03-28-2016 at 04:15 PM
    I was going to do something like that, but cut the pipe at a 45d, with the cut facing up, that
    way the flap will fall down and rest on the cut. The weight of the flap ought to be enough to
    'seal' it. ...

  • Posted in thread: DIY Beer Line Cleaner on 03-25-2016 at 08:23 PM
    I just forced the pin lick post right onto the plastic.Man... We don't want to know! :ban:
    :ban: :ban: :D

  • Posted in thread: Walkin Cooler TX Build on 03-24-2016 at 03:54 PM
    The hard part in my mind is designing a flapper on the end to close off the pipe when the fan
    is off to prevent cold air waterfalling and crashing my yeast.Perhaps using a dryer vent
    exhaust would wor...

  • Posted in thread: Show us your panel on 03-21-2016 at 06:29 PM
    So, if you have a failure between your panel and the wall, the control panel will assume
    everything is ok, relying on the non-GFCI breakers in your house's panel to trip? Am I reading
    that correct? Th...

  • Posted in thread: Low bucks motorized grain mill on 03-17-2016 at 07:56 PM
    I'm using an 850W ATX power supply (massive overkill at 70+ amps but since it was sitting in my
    basement, it was free). It is a "single rail" with two modular PCI connections. I took a single
    12v wire...

  • Posted in thread: Low bucks motorized grain mill on 03-17-2016 at 04:33 PM
    Ok @BeardedBrews @BeardedIdiot. I know you one of you had a mix-up on your Love Joy's. What
    sizes did you end up using? What are you using for your power supply?

  • Posted in thread: Low bucks motorized grain mill on 03-04-2016 at 07:41 PM
    Going to read this thread later... Sub'd

Following Stats
0 COMMENTS
POST A COMMENT