Last Activity:03-12-2015 11:40 PM
1 Likes on 1 Posts
Posted in thread: Alternative CO2 Regulator Pressure Adjustment Screw on 12-12-2014 at 10:46 PM
Yeah. Did that before but this is definitely easier to turn. Cheers!
Posted in thread: Regulator screw DIY on 12-12-2014 at 10:41 PM
Anyone else tired of grabbing a screwdriver to adjust your regulators. My new ones have a knob
to make it easy but I have 3 Taprite regulators that I fixed. Went to local hardware store and
bought a s...
Posted in thread: Alternative CO2 Regulator Pressure Adjustment Screw on 12-12-2014 at 10:27 PM
I too was tired of grabbing a screwdriver to adjust my regulators. My new ones have a knob to
make it easy but I have 3 Taprite regulators that I fixed. Went to local hardware store and
bought a split...
Posted in thread: Beer line tests & solution to the "plastic" taste on 04-28-2013 at 07:37 PM
I have always used a tapered punch or a center punch tool to stretch the hose end. I'll use a
heat gun or lighter to heat up the end of the hose with out melting it and then stretch the
hose to fit ov...
Posted in thread: Star-San vs. Iodophor - FIGHT! on 03-15-2013 at 03:44 AM
Posted in thread: Favorite Brewing Software on 12-06-2010 at 03:17 AM
I'd sure like to check out spreadsheet you are using. I am not too savy on building one but I
am looking for something a little different than BeerSmith.Thanks!
Posted in thread: How many gallons of homebrew in 2010? on 04-02-2010 at 03:58 AM
2200+ gallons in 1997.....yes, twenty two hundred in the old garage, the park, group brews, but
mostly in that old garage with 8 refers..Love my lagers...(10 g batches)yeah, that was sick.
Lots of tim...
Posted in thread: Mill Speed? on 01-18-2010 at 01:47 AM
I used six inch diameter rollers. I believe the idea was that the larger the roller,(6-8")the
better "pinch" it would have on the grain. Grains are slightly heavier on one end and if the
freely falls ...
Posted in thread: Mill Speed? on 01-17-2010 at 09:34 PM
1992 Zymurgy Special Issue on building your own roller mill called for aprox 100 rpm. I built
one in 1995 with similar design and our LHBS now uses it exclusively! I will be building
another one this ...