High_Noonan

Gift Premium Subscription To High_Noonan

Join Date:

02-10-2010

Last Activity:

10-28-2012 4:21 PM

Likes Given: 1

1 Likes on 1 Posts 

    ABOUT ME

  • Geeking,brewing beer
  • Network Geek
  • I have been brewing since the great Home Brew Wave struck New England back in the early '90s. It was on-again-off-again for a long while being an apartment dweller. But now that I am married, I have a garage to use. Just recently, I put enough pieces of stainless together to make a small AG brew system which I am trying to use every two weeks until my first baby comes along in late December.
  • Old world ales and small beers interest me.
    I've never taken a gravity reading that I trust.
  • Air
  • Air
  • A couple 22oz bombers from each of the recent batches for aging and gifting.
  • FatSam
    English Mild Ale (11a)
    Road Dog Porter clone (that I can not wait to sink my teeth into)
  • Male
  • Married
  • Attleboro
  • MA

LATEST ACTIVITY

  • Posted in thread: A question about mashing on 09-04-2012 at 06:33 PM
    Alright. Cool. I am not alone in this then!Thanks for the input.I seem to always overshoot the
    strike water temp, so I will keep a pot of cool water on hand at the ready from now on.One last
    thing, an...

  • Posted in thread: A question about mashing on 09-04-2012 at 06:11 PM
    I brewed up my first lager earlier this summer and it is now, finally, ready for drinking.I was
    a bit disappointed to find that is a bit sweeter than I would like, or would expect, for a
    lager. Being ...

  • Posted in thread: Sow me your pump/plate chiller stand on 08-09-2012 at 05:48 PM
    That is a great idea!I have a platform I threw together out of some scrap wood and I am not all
    that happy with it.It works, but takes up way too much room for storage.Can you show me the
    bottom of th...

  • Posted in thread: Lakeside Lager on 07-07-2012 at 01:45 AM
    Racked this to secondary last night.Took a gravity reading tonight...and a little sample.Holy
    crows! This is a good beer...and it is still cooking!

  • Posted in thread: My corny spunding valve build on 07-05-2012 at 01:51 PM
    I'm in tampa so I will be paying a lit of attention to this thread. I have three sankes do you
    think this is feasible for sanke use?Absolutely. I believe that the sanke path is surest.Trying
    this in 5...

  • Posted in thread: My corny spunding valve build on 07-04-2012 at 05:48 PM
    Thanks for the info.I think I have a bum Corny for doing pressurized ferments in. It doesn't
    seem to seal properly.That one may be sold back to my LHBS.

  • Posted in thread: Primary fermentation in corny keg on 07-03-2012 at 06:59 PM
    I would think not.It probably wouldn't hurt to lay a blanket of CO2 on top of the wort, but if
    your yeast get to work in a hurry, I wouldn't think it would be all that necessary.

  • Posted in thread: My corny spunding valve build on 07-03-2012 at 02:10 PM
    CS223,I have my first pressurized ferment going (I think), but I am not seeing any pressure
    reading on the gauge. I am using a two-keg setup with a quart of boiled water in the bottom of
    the "blow-off...

  • Posted in thread: Primary fermentation in corny keg on 07-02-2012 at 05:36 PM
    I have my first pressurized fermentation under way!Can't wait to get home tonight to see if
    there is actually any pressure building in there.

  • Posted in thread: CO2 Charger for Racking? on 06-27-2012 at 03:43 PM
    Thanks for the input, folks.I was hoping that you could just squeeze a bit of gas at a time
    from the charger and this seems to be the case.If worse comes to worst, I will grab the CO2
    tank and regulat...

Following Stats
FORUM SIGNATURE
Tap 1: House Porter Tap 2: StarSan Tap 3: StarSan Tap 4: StarSan Primary: Lakeside Lager Primary: 10-day Mild Ale Aging/Carbing: The Brewer On deck: ?
0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS