VIEW MY

heapyjeepy

Gift Premium Subscription To heapyjeepy

Join Date:

09-13-2010

Last Activity:

11-28-2014 6:36 AM

    ABOUT ME

  • Building my brew rig and
    using it.
  • Engineer
  • Started brewing in 2010 and worked my way up to an automated all grain brewing monstrosity.
  • Male
  • Married
  • Denver
  • CO

LATEST ACTIVITY

  • Posted in thread: Brewtroller pressure sensors on 10-11-2014 at 09:57 PM
    Sorry to be the barer of bad news but OSCSYS closed down. Unless you have been in recent
    contact with them, I'd look into where your package was delivered to. Check out they're
    homepage.

  • Posted in thread: Brewtroller pressure sensors on 10-11-2014 at 09:48 PM
    It doesn't sound like the sensors that are bad. If the value changes from the sensor when you
    blow into it, they work. It sounds more like its the program not excepting the sensor input.

  • Posted in thread: Brewtroller pressure sensors on 10-11-2014 at 08:05 PM
    If the sensor is work, and you have 5v and a ground. You shouldn't have any problems. It'd just
    be the configuration after all that.

  • Posted in thread: Brewtroller pressure sensors on 10-11-2014 at 08:04 PM
    Read up on how to configure the volume measurements on the oscsys website. You will need to add
    a gallon, and set 1 gal to the sensor value. My sensor values were around 40 at the minimum and
    went up ...

  • Posted in thread: How to keep water from freezing in brew rig on 02-09-2014 at 04:25 PM
    Thanks for all the ideas everyone!Sent from my iPad using Home Brew

  • Posted in thread: How to keep water from freezing in brew rig on 02-09-2014 at 04:23 PM
    Sounds like the vodka would be the best bet. I'd rather have residual vodka than antifreeze.
    Even if it's NSF safe. The taste can't be good... I'll have to see where a few liters of bottom
    shelf will ...

  • Posted in thread: How to keep water from freezing in brew rig on 02-07-2014 at 02:06 PM
    :smack::smack::smack:Did you know that water freezes in the winter?! Apparently that minor
    detail slipped past me this winter when i left water in my system and it froze,
    breaking/splitting some coppe...

  • Posted in thread: New brewtroller power box on 12-03-2013 at 03:08 AM
    I also needed a better way of knowing how to wire my IC. So I took a picture of the top and the
    bottom of the IC and overlaid them with a bit of transparency one the top one. After mirroring
    the top o...

  • Posted in thread: New brewtroller power box on 12-03-2013 at 03:03 AM
    I recently tested out the power supply and found a nice way to hold up my main power board. The
    power supply makes a bit of a high frequency sound but I assume it's because of the fact there
    isn't any...

  • Posted in thread: New brewtroller power box on 12-02-2013 at 03:11 AM
    Started working on the new setup after my brewtroller and remaining projects were completed.
    Here are some picks of the control box so far. I'm running a direct fire system and using a
    custom made cir...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS

PHOTO OF THE DAY