VIEW MY

Haggismaximus

Gift Premium Subscription To Haggismaximus

Join Date:

01-27-2010

Last Activity:

03-31-2011 4:14 PM

    ABOUT ME

  • Berkeley, CA
  • Single

LATEST ACTIVITY

  • Posted in thread: Brewatron on 03-08-2011 at 10:53 PM
    Well got it all finished and moved over to my friends place. I do have to add a heat shield for
    the sight glass on the Boil kettle, and maybe a few small things, but we fired it up and things
    worked a...

  • Posted in thread: Brewatron on 01-18-2011 at 03:46 PM
    Yes, grinding inside the keg sure was a hassle.The rig is basically finished, and we've brewed
    on it twice so far. Welded up an Aluminum control box and got the frame painted. Just need to
    clean and r...

  • Posted in thread: RIMS Flow Rate on 09-11-2010 at 07:18 PM
    So we finally got around to doing a test run on the Brewatron and everything seemed to work out
    great accept a high amount of heat loss in the RIMS cycle.What type of flow-rate are you guys
    using for ...

  • Posted in thread: Brewatron on 07-26-2010 at 03:50 PM
    Thanks, some of the welds are much nicer then others.I used hard-line throughout the system. If
    I were to do it again, I would have the same setup, but use 3/4" silicon from the fluid
    manifolds to the...

  • Posted in thread: Brewatron on 07-26-2010 at 06:15 AM
    Well things are taking longer then anticipated, mainly because I've been busy. Almost finished,
    hope to have it done, save the electronics, this week or next. Poor quality video of the pumps
    and manif...

  • Posted in thread: Blichmann Auto Sparge for Keggle? on 06-10-2010 at 05:55 PM
    Just got my Auto Sparge in the other day and noticed that the float valve seemed a little lose
    and there was quite a bit of slop between the piston and bore. I took it apart and saw that the
    piston do...

  • Posted in thread: B3/Blichmann Conical Manufacture on 06-10-2010 at 05:46 PM
    Was at B3 yesterday and they said they get their conicals from China...

  • Posted in thread: Blichmann Auto Sparge for Keggle? on 06-08-2010 at 06:42 PM
    Thank you!

  • Posted in thread: Blichmann Auto Sparge for Keggle? on 06-08-2010 at 06:37 PM
    OK thanks, do you know the thread size of the male part? 3/4 NPT?

  • Posted in thread: Blichmann Auto Sparge for Keggle? on 06-08-2010 at 05:59 PM
    Anyone have any experience using the Blichmann Auto Sparge in a keggle? Curious if there could
    be clearance issues with a large grain bill.

FORUM SIGNATURE
Current Project: Brewatron Gallery
0 COMMENTS
POST A COMMENT