Last Activity:07-23-2016 2:17 PM
1 Likes on 1 Posts
Posted in thread: DIY Tap Handle Advice on 07-18-2012 at 08:06 PM
You might need a jamb-nut set into the top die to secure everything in place. Unless you can
run a tap (internal threading tool) through all the dice. In which case you may not even need a
Posted in thread: DIY Tap Handle Advice on 07-18-2012 at 06:31 PM
20mm hole through the die? That's over 3/4inch :eek: I used a 5/16 or 3/8inch (sorry can't
remember) "connecting" nut that I rounded in a lathe (You could do the same thing w/ a drill
and a file) and ...
Posted in thread: So who's brewing this weekend? on 12-25-2010 at 05:26 PM
Doing a Northern Brewer Cream Ale extract kit tomorrow.
Posted in thread: Large Giveaway - Fermenter, Mash Paddles, Thermapen on 11-27-2010 at 04:34 AM
Posted in thread: Show us your Kegerator on 05-27-2010 at 09:40 PM
Nice work ubermick!
Posted in thread: Switching between two kegs in a single kegerator on 05-15-2010 at 11:43 PM
Just poured 1/2 a glass of the mix , chugged it, and was golden from then on.Fixed that for ya.
Posted in thread: Switching between two kegs in a single kegerator on 05-15-2010 at 02:30 AM
I don't see any issues coming from inside the lines other than the 'blended' 1st pour. The
posts might need to be sanitized before reconnecting them after sitting unconnected though.
Posted in thread: Show us your Kegerator on 05-15-2010 at 02:11 AM
I didn't take any pics of the fridge before I started working on the door. I did however take a
picture of the temporary door I made so I could start carbing my 1st barrel. door. fitting.
Posted in thread: Mah Kegerator Build. on 05-13-2010 at 03:09 AM
TRON.lolI didn't even think of that. Now It'll never be the same... :)
Posted in thread: Mah Kegerator Build. on 05-13-2010 at 02:23 AM
Hellz Yah! That's pretty dope Ryan! When is the beer going to be flowing through it?Thanks Tim!
It's exactly how I envisioned it and I can't wait for my 1st pour. I'm going to hook-up a line
to the Am...