VIEW MY

gx1400

Gift Premium Subscription To gx1400

Join Date:

04-18-2012

Last Activity:

01-23-2014 11:01 PM

1 Likes on 1 Posts 

    ABOUT ME

  • Single
  • Kansas City
  • Missouri

LATEST ACTIVITY

  • Posted in thread: Help with Fermentation Chamber Condensation on 06-27-2013 at 03:50 PM
    "Evadry" is it?That is it. Was at work and couldn't get into personal email to check order.

  • Posted in thread: Help with Fermentation Chamber Condensation on 06-26-2013 at 10:28 PM
    I had a TINY gap in the weather sealing of my keezer and had a lot of condensation issues. I
    would recommend making sure you have a solid seal and then throw in a dessicant. I can't
    remember what's ca...

  • Posted in thread: Pump In (Inside) a Toolbox - Stainless on 06-25-2013 at 09:06 PM
    I just built a very similar pump box, though not quite as clean (tried to jury-rig tools I had
    to do the job and ended up buying the tools I should have used after the fact... may rebuild
    one of these...

  • Posted in thread: Washer & Nut suggestion for Thermowell w/ 1/2" NPT Threads on 06-04-2013 at 10:55 PM
    Can anyone suggest a washer (nylon?) and nut (SS or nylon?) for the threads of a 1/2" NPT
    fitting from a thermowell? I plan to drill a 3/4" hole in the lid of my HDPE Speidel fermenter,
    so I'm looking...

  • Posted in thread: Power supply for Rule 140 Bilge Pump on 03-01-2013 at 06:38 PM
    I bought a Rule 140 Bilge pump to push air into 1 1/2" PVC in my keezer for air circulation.
    I've seen this pump recommended, does anyone use this pump? If so, what do you use for a power
    supply (volt...

  • Posted in thread: All grain equipment, supplies, kegs, kegerator in Chicago on 12-26-2012 at 12:19 AM
    If you are unable to sell the tool box and/or the quick disconnect fittings and hoses, I would
    be all over it. Understand you don't want to part out, but if you change your mind or run into
    trouble, I...

  • Posted in thread: Original Blichmann floor burner legs!!! on 12-22-2012 at 08:40 PM
    I upgraded mine to the longer legs last month and have the old ones in my garage back in
    Albuquerque, NM (in Missouri for the holidays till Jan 2nd). How much would you give for them,
    pre-shipping?

  • Posted in thread: Blichmann Therminator Plate Chiller on 11-23-2012 at 05:00 PM
    whats your cost to ship to 87111? ill most likely take it

  • Posted in thread: Vissani Fermentation Chamber on 11-19-2012 at 11:38 PM
    Is there a good way to route wires into the back of the unit? I have the heating element and
    temp probe going under the door seal. I use a towel to block airflow from that spot, but I
    would rather hav...

  • Posted in thread: Vissani Fermentation Chamber on 11-18-2012 at 07:35 PM
    Built mine about a month ago and now have my 2nd brew fermenting away in it. Works like a
    champ... fits a 6.5 gallon carboy with no space concerns
    whatsoever!https://plus.google.com/photos/10514060791...

0 COMMENTS
POST A COMMENT