greyghost

Gift Premium Subscription To greyghost

Join Date:

12-22-2011

Last Activity:

08-27-2016 4:55 AM

Age:

78 years old

Likes Given: 3

18 Likes on 15 Posts 

    ABOUT ME

  • Male
  • Married
  • Woodinville
  • WA

LATEST ACTIVITY

  • Posted in thread: Question about recirculating with BIAB on 08-06-2016 at 03:29 AM
    I just bought one of those tiny little pumps off Amazon for this very thing. I guess I am going
    to need to put a hole in my kettle lid? Also, what kind of sprayer/head do I put on the
    inside?https://w...

  • Posted in thread: HomebrewTalk T-shirts Pre-Order on 08-06-2016 at 03:10 AM
    Got my T shirt today nice shirt. One complaint it came with $1 postage due. Cheap shot.

  • Posted in thread: Spike Brewing Kettle Giveaway on 07-29-2016 at 05:31 AM
    In

  • Posted in thread: HELP! I cant find a thread on 07-10-2016 at 04:21 AM
    Is this it?

  • Posted in thread: Walk me off the RIMs ledge...or not! on 06-28-2016 at 05:02 AM
    I will have to say the RIM's system is the best thing since sliced bread and I controlled it
    with a 310 inkbird.

  • Posted in thread: Walk me off the RIMs ledge...or not! on 06-25-2016 at 05:21 AM
    The RIMS tube isnt too hard to clean, maybe five minutes of labor.If I could get you off your
    azz I could find for myself.:off:

  • Posted in thread: Ballast Point - Victory at Sea. This is pure beer nirvana. on 06-08-2016 at 03:11 AM
    I agree with Dragon it was not what I want, there was too much roast to suit me. I like porters
    but I will pass on that one.:mug: i agree.:p

  • Posted in thread: Kegco Mill? on 05-20-2016 at 01:25 AM
    I'm telling you this thing has to be a knock offYes but with some big improvements. Sealed ball
    bearings and a 1/2" drive shaft.

  • Posted in thread: Kegco Mill? on 05-19-2016 at 02:09 AM
    There was some questions about the monster mill extensions fitting the kegco mill. I got one
    and it fits fine. $25 plus shipping. The bolt holes even line up.

  • Posted in thread: New BIAB brewer efficiency question on 05-17-2016 at 01:58 AM
    I have found that using the marks on the mill are not the same side to side. This is on 2 mills
    I have setup. Use a feeler gauge on both ends if you want it right.

Following Stats
0 COMMENTS
POST A COMMENT