VIEW MY

grandequeso

Gift Premium Subscription To grandequeso

Join Date:

08-20-2012

Last Activity:

06-12-2014 2:26 PM

Age:

34 years old

Likes Given: 7

10 Likes on 10 Posts 

    ABOUT ME

  • Bicycles,Beer
  • Journeyman Electrician
  • Morrissey
  • Engaged
  • Jacksonville
  • Fl

LATEST ACTIVITY

  • Posted in thread: GFCI Protection 240V 3 Wire? on 05-31-2014 at 07:10 PM
    Death to all false neutrals!

  • Posted in thread: wiring gfci breaker for two wire on 05-31-2014 at 01:31 AM
    You got it if you have no neutral load leave that terminal open on the breaker

  • Posted in thread: Screw down wire or use crimp terminal on 04-29-2014 at 12:47 AM
    I wouldn't complicate things. If you have screw terminal available use it. As long as it is
    rated for the awg (size) of wire you are working with you will be fine.

  • Posted in thread: 4 prong dryer vs twist lock receptacle on 04-28-2014 at 04:26 PM
    I'm personally in favor of twist locks in all my equipment. I've seen tons of range and dryer
    plugs and recepts fail over the years. I've only seen a couple twistlocks burn up. Typically
    range and dry...

  • Posted in thread: Has any one ever used this new pump? on 04-25-2014 at 10:04 PM
    No, 500ma = .5a . you're going to need at least the motor load of 1.05a. Just to not burn up
    your power supply

  • Posted in thread: wiring help on 04-18-2014 at 11:52 AM
    If you have 10/3 hhng to your disconnect. hhg to your equipment.

  • Posted in thread: wiring help on 04-17-2014 at 07:14 PM
    I would just keep it simple. Install a gfci breaker in the panel on the new circuit that feeds
    your controller. Then run 10/2 romex to a L6-30r receptacle.

  • Posted in thread: Need help with power to garage on 04-17-2014 at 02:18 AM
    If you plan on running a 50a brew panel ever I strongly suggest running a minimum 60a sub feed
    circuit it the garage. Otherwise if you're going with the standard 30a set up you will only
    need 10awg wi...

  • Posted in thread: I need some help from our resident electric brewing specialists on 04-12-2014 at 10:33 PM
    Id cross my fingers and hook up 240 volts to it, its likely just a typo. Much of the world runs
    at 200 or 220v. line to neutral.

  • Posted in thread: GFCI Protection 240V 3 Wire? on 04-12-2014 at 10:26 PM
    Sub panel is only required to have grounding electrode (rod, plate, pipe... Depends on what is
    accepted where you live based on the soil) if it is a detached building.

0 COMMENTS
POST A COMMENT