Last Activity:05-14-2015 6:57 AM
Likes Given: 5
17 Likes on 13 Posts
Posted in thread: Bru Gear on 05-14-2015 at 11:57 AM
I got my HERMS in and I'm getting some of the TC fittings from BrewHardware to put on the top.
I will link them below. I already run a lot of his stuff in my system and old AG system. His TC
Posted in thread: Bru Gear on 05-13-2015 at 01:03 PM
Finally got my herms coil yesterday.I like those 90's on top, where'd you get them? I imagine
I'd need them to stop the hoses from kinking.
Posted in thread: Bru Gear on 05-11-2015 at 05:16 PM
Got a little closer to having everything ready. Built my table but it turned out to be a little
tall on the casters so I'll be removing those for a little while. Got the rest of my stuff on
the way an...
Posted in thread: NEW StrangeBrew Elsinore Thread on 05-07-2015 at 01:19 PM
Jangeeva has a blog with lots of documentation on it. I have a load of pages at (some are out
of date, but not by much), I have no problems with anyone converting it to a wiki and using ads
Posted in thread: NEW StrangeBrew Elsinore Thread on 05-07-2015 at 12:28 AM
Can you start a new one again, this one is too long.....All of this information is spread
across hundreds of posts. This warrants a Wiki, not necessarily a new thread :) :tank:Doug, I
have all the hos...
Posted in thread: Bru Gear on 04-29-2015 at 03:58 PM
Gladly..Jay,Is it possible to list out the parts you sell that are known to work with Bru-Gear
kettles? I think that was the intention of the original request above. A lot of us are looking
to fill in...
Posted in thread: Bru Gear on 04-29-2015 at 02:18 PM
I found at Brewers Hardware 6" 1.5 triclover extension that works perfectly with my HLT to get
the HERMS coil within an inch of the bottom of the HLT. They also have 3" in stock, I imagine
4, and 5" a...
Posted in thread: Bru Gear on 04-28-2015 at 04:18 PM
I haven't received mine yet, so I'm assuming I'm getting the new one. How is yours working as
far as having the ports on top? Any issues with a pump? I know it shouldn't but just looking
for hands on ...
Posted in thread: Bru Gear on 04-28-2015 at 02:01 PM
Any suggestions for us who have the "original" HERMS coil and lid? I've emailed them and I
don't think they'll replace it with the new one (basically just longer arms from the lid). It
seems like a gr...
Posted in thread: Bru Gear on 04-24-2015 at 01:33 PM
I am using an Adcraft IND-C120V https://www.katom.com/122-INDC120V.html It works great with the
BCS turning on and off as needed. I haven't tried to use it for boiling. I think you need their