Gammon N Beer

LATEST ACTIVITY

• Posted in thread: Drill for a Barley Crusher on 05-25-2013 at 05:37 AM
  The other thing to consider is that about ten years ago John Menard pleaded out on a charge
  that he took arsenic from his company and put it into the residential garbage waste stream. So
  this billiona...

• Posted in thread: Growler fillers for Perlicks 9.99 Shipped on 05-09-2013 at 02:46 AM
  I have never tested one on a Ventamatic. These are designed for Perlick 525 and 575's.Anybody
  tried this product on Ventimatic's?II would be willing to test for you if you need this done.

• Posted in thread: Super Simple 15G Plastic Conical on 05-02-2013 at 01:44 AM
  I called and asked about the 1.5" sight glass and was told it holds 5oz.So, to compare apples
  to apples what is the volume of the 2" sight glass without the 1.5" to 2" adapter?

• Posted in thread: $500 to spend on upgrading. What should I do? on 04-30-2013 at 04:38 AM
  When I first got into making starters I was brewing 5 gallon batches. I bought a 5L flask and
  loved it.Then, when I went to 10G batches I had what I needed.I am now purchasing and upgrading
  equipment ...

• Posted in thread: Boilr off rates with a 25 Gallon Mega Pot in Beersmith on 04-29-2013 at 12:25 AM
  12-15% is good place to start and then make adjustments after your first brew. So if you were
  doing a 20 gallon batch and you were assuming a 12% boil off, then you would want to boil 20 /
  0.88 = ~22....

• Posted in thread: Boilr off rates with a 25 Gallon Mega Pot in Beersmith on 04-27-2013 at 09:54 PM
  I will be introducing my new boil kettle to the flame tomorrow. I know there are a lot of
  variables in determining boil off rates. But I would like to start the process of configuring
  the rate from so...

• Posted in thread: Super Simple 15G Plastic Conical on 04-26-2013 at 05:21 PM
  if it's not too late you might consider going to a 2" sightglass with a 1.5" to 2" connector.
  It holds about 400 ml (about 14 oz) of ...a bit more than the 1.5" clamped directly to the
  bottom valveTha...

• Posted in thread: My Stirplate does not work properly on 04-25-2013 at 04:01 AM
  I have a, "cow magnet". Once my wort is cooled and ready for the stir plate I pitch the yest. I
  then tip the flask so the stir bar that has been in the flask for before the boil drops. At
  that point I...

• Posted in thread: new brew station up and running on 04-25-2013 at 01:48 AM
  Well done. Just make sure the ceiling in that garage is fireproof. (When I set up my multi tier
  system in the garage a number of years ago, I had never really looked up. When I did I found
  old 1970'is...

• Posted in thread: Yooper is now an Admin! on 04-23-2013 at 04:54 PM
  Good selection and no doubt a hard one considering all of the quality talent of this place.