VIEW MY

gabeweisz

Gift Premium Subscription To gabeweisz

Join Date:

11-23-2007

Last Activity:

03-29-2014 9:06 PM

Likes Given: 2

2 Likes on 2 Posts 

    ABOUT ME

  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: More Beer heading to PA on 07-07-2013 at 02:13 PM
    That'll be nice - there's really only one shop (3 locations, but same shop) around Pittsburgh,
    and there hours aren't great.

  • Posted in thread: Best beer in Maryland? on 06-29-2013 at 03:40 PM
    If in Baltimore, brewer's art in Mt Vernon. Also heavy seas and Pratt st. Ale house.

  • Posted in thread: Too much malt in my rye/wheat on 06-02-2013 at 08:09 PM
    It's going to be stronger than expected, but not rediculously so. Give it a bit more
    fermentation time and call it an "imperial" and you'll be all set.

  • Posted in thread: Setting up a Homebrew in Israel on 09-29-2012 at 10:29 PM
    Very nice work guys!

  • Posted in thread: Corona style mill on 08-21-2012 at 02:45 AM
    13 mm metric bolt fit mine. Need an adaptor to attach a hex socket to the drill.The bolt head
    eventually rounded off on mine so I just cut it off and attach the chuck to the shaft. Works
    fine but shak...

  • Posted in thread: Low Efficiency - Troubleshooting w/ No Luck on 08-21-2012 at 02:38 AM
    Adding all the grain at once could be a problem because you might have a dough ball. Try adding
    a bit at a time and stirring.

  • Posted in thread: Major Upset this weekend brewing! on 08-21-2012 at 02:33 AM
    Most likely fine. Don't sweat it.

  • Posted in thread: Arduino - Networked Temperature Monitor on 07-28-2012 at 07:33 PM
    Pretty neat. Since you have the arduino and probes, why not also get some SSRs and control the
    temperature too?

  • Posted in thread: sanke D "wing handle" coupler disassembly on 07-08-2012 at 10:46 PM
    You can get a replacement wing (made out of metal) if you want to repair it. I did (although
    promptly started brewing enough that I don't use Sankey couplers any more ...

  • Posted in thread: Low efficiency with corona mill :/ on 07-08-2012 at 10:40 PM
    Using washers to make the sides of the places even helped me with mine, as well as cranking it
    as tight as it would go (I keep it just loose enough for the plate to be able to turn)

0 COMMENTS
POST A COMMENT