Last Activity:10-02-2012 11:07 AM
Posted in thread: Cheap nano Pumps? on 09-20-2012 at 05:38 PM
If you are brewing big batches you will want to maximize your flow rate. I've seen people talk
of doing so by not using restrictive fittings (making sure their holes are at least as big as
the ones in...
Posted in thread: propane stove on 09-20-2012 at 12:18 AM
I had a Bayou Classic banjo cooker briefly, then switched to a Blichmann. In addition to being
quieter I am pretty sure the Blichmann is more efficient. The burner on the banjo was too far
away from t...
Posted in thread: Cheap nano Pumps? on 09-19-2012 at 04:15 PM
Little Giant pump on Ebay here:
Posted in thread: Kegging system questions on 08-22-2012 at 11:07 PM
I just bought a Brew Logic Dual Tap Draft System with Pinlock kegs from Midwest Supplies. They
came slightly pressurized, which I thought was a good sign.I put some water + oxyclean in one
of them, cl...
Posted in thread: Budweiser mini beer fridge (Husky HM134-EL) on 07-16-2012 at 09:44 PM
I am hoping to get/build a kegging system (tired of bottling) with 2 taps that can hold a pair
of corny's.I won one of these Budweiser mini beer fridges (Husky HM134-EL) on a local radio
Posted in thread: Questions about March Pumps answered by the Factory! on 03-05-2012 at 05:17 PM
Just won an ebay auction for a pump. My intention is to use it for cooling wort by pumping
through a plate chiller. So the question is, which is better:Kettle->Chiller->Pump->or
Posted in thread: Burner questions on 02-02-2012 at 08:16 PM
I decided to go with a KAB4. Near as I can tell Blichmann has just taken the same burner and
built a stainless stand to put it in, which is nice but more than I need right now. The
regulator even look...
Posted in thread: Building a stir plate, check out this USB adjustable computer fan on 02-02-2012 at 01:14 AM
What I did on mine, since the computer magnet was curved and difficult to determine the center,
was I put my stir bar on it while positioning. I think it is more important to have it centered
Posted in thread: Burner questions on 02-02-2012 at 01:07 AM
Ok I am down to the last component for my switch to all grain: a propane burner. I have a few
questions..- I will be using it on a 15 gallon aluminum pot. I think I have narrowed my choices
down to ei...
Posted in thread: First use of cooler mash tun: fail!; solution: cake dummy? on 01-31-2012 at 10:12 PM
I didn't pre-heat no, i just heated the water to 5 degrees above my target temp. I will preheat
as you suggest next time. As for a bad reading, I did top up yes, i suppose it is possible.