Last Activity:05-20-2012 10:39 PM
Posted in thread: From Kansas? Midwest? on 03-07-2012 at 06:59 PM
Salina, KS....Rock ChalkCheck out the Salina Brewers Guild for anyone in the area. Tanglefoot
came to our last meeting so that was cool.
Posted in thread: 4 faucet jockey box build on 03-14-2011 at 08:51 PM
Everything works great. The only issue, not really an issue though, is that it is pretty big
and heavy. Could have used a smaller cooler, but my buddy had that one lyin around so we save
Posted in thread: 4 faucet jockey box build on 03-14-2011 at 08:02 PM
a great pic but works great!!!We had a keg of warm/hot water we used to flush out the cold
plate and also hooked that up to seehow it works... worked great!! With just the little ice we
put on the p...
Posted in thread: How can I get the reddest ale possible? on 03-13-2011 at 03:10 AM
I've used Ken Lenard's advice of using a combo of Crystal 120 and Special B....awesome RED
color and didn't have an over the top sweet or raisiny flavor you might expect for 8 oz of each
in an 1.045 a...
Posted in thread: capacitor to motor or mill - wiring help on 02-25-2011 at 09:30 PM
No problem. Actually I plan on attending the Wichita Homebrewers Organization meeting tomorrow
(2/26). Are you part of W.H.O.?No, I live in Salina and am the founder and president of the
Posted in thread: capacitor to motor or mill - wiring help on 02-25-2011 at 04:21 AM
I've been using the same exact motor in a clockwise rotation for my Barley Crusher without any
issues. It munches right through it. Got the Barley Crusher set to factory defaults and getting
Posted in thread: capacitor to motor or mill - wiring help on 02-24-2011 at 03:09 PM
Sounds like you did good. Now some info for you as you might be A-Ok as is. (depending on how
you are viewing your motor setup).Direction of rotation is normally determined by viewing it
from the wire...
Posted in thread: capacitor to motor or mill - wiring help on 02-24-2011 at 02:55 AM
Some info for you. That motor was originally designed for CCW rotation. It will have lower
torque if run with CW rotation. The motor is not designed for use with a start capacitor. Do
not do that. If ...
Posted in thread: capacitor to motor or mill - wiring help on 02-23-2011 at 05:12 PM
Glad I stumbled across this thread. I have the exact same motor and am wanting to wire it just
like kegtoe, but with an added twist....I also have a start capacitor. I have build my table
and wired it...
Posted in thread: Large Giveaway - Fermenter, Mash Paddles, Thermapen on 11-26-2010 at 04:04 AM