Last Activity:07-29-2016 3:16 AM
7 Likes on 7 Posts
Posted in thread: PWM..Show us How on 09-18-2016 at 05:28 PM
Here's the drawing that was on the first page.
Posted in thread: Brewer's Hardware 15 Gallon Stainless Steel Conical Fermenter Giveaway! on 08-13-2013 at 01:27 PM
I'm in. Thanks!
Posted in thread: FS: RIMS Heater Tubes on 08-05-2011 at 01:59 PM
The heating element is shaped like a rod and is pictured in the first post. Rod-shaped heating
elements are easy to find in low to medium wattages. Check ebay for 'watlow firerod' and there
are a ton ...
Posted in thread: FS: RIMS Heater Tubes on 08-05-2011 at 02:02 AM
Posted in thread: PWM..Show us How on 05-09-2011 at 02:05 PM
Be careful here. I know some might argue the HBT board goes a bit overboard when it comes to
safety, but is that really possible when we're using water, metal tanks and 30-50 amps at 115
to 230 V?Spec...
Posted in thread: PWM..Show us How on 05-06-2011 at 05:35 PM
Can you show photo's of your unit with the wiring schematic:ban:Here's a diagram I made. I
tried to keep it simple. Hopefully it's enough to get you going. It's easier to understand once
you get your ...
Posted in thread: PWM for Boil Kettle Control on 05-03-2011 at 12:49 PM
This question may have been asked but, all I have to do with the Bakatronics #FK804 kit is
replace the kits C1 cap with a 2.2uF cap and everything should work fine? Nothing else needs to
be modified o...
Posted in thread: PWM for Boil Kettle Control on 04-06-2011 at 01:20 AM
Did you get the polarity right when you soldered the capacitor in place? Polarity matters with
Posted in thread: PWM for Boil Kettle Control on 03-26-2011 at 03:34 PM
Ok, I have to ask this: Why bother with PWM control on your BK? I have a 5500 watt element in
my keggle running with no control. Works great and have not had a boil over yet. Maybe because
of my water...
Posted in thread: PWM for Boil Kettle Control on 03-26-2011 at 01:56 PM
This may be a dumb question, but if you used this unit, it appears you can adjust the frequency
without changing capacitors, correct? Would this be a better unit than the 7.99 one from
Bakatronics? I ...