VIEW MY

flatulentfox

Gift Premium Subscription To flatulentfox

Join Date:

01-23-2011

Last Activity:

09-01-2015 7:42 PM

Likes Given: 2

4 Likes on 4 Posts 

    ABOUT ME

  • Single
  • nashville
  • tn

LATEST ACTIVITY

  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 06-23-2015 at 08:14 PM
    Yeah, i have never needed to travel with my brew panel, but its nice being able to close it up
    and put it out of the way some where for cleaning up, moving things around, etc.

  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 06-23-2015 at 08:12 PM
    Is that your gfci mounted to the panel? I have been thinking about doing the same. Any
    suggestions?You can see how it is mounted in the pictures on the first page. I used a piece of
    plastic i had layi...

  • Posted in thread: Element position in kettle on 06-02-2015 at 03:13 PM
    You already have the silver solder supplies, right? That would be the best solution to try and
    plug any holes i would think, assuming you know where the trouble spot is.

  • Posted in thread: Economy Kettle on 05-15-2015 at 09:53 PM
    I don't know how large you want to go, but if you have the resources to convert them, keggles
    can be had for cheap if you are are patient.

  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 05-01-2015 at 03:26 PM
    I added Bobby's solder TC element fittings and all stainless elements. So far I am really
    pleased.

  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 05-01-2015 at 04:59 AM
    also got a stainless chugger pump head. It pumps noticeably faster than the plastic March
    head I had. The inlet port is a larger bore and the fins on the impeller are larger than those
    of the March.

  • Posted in thread: Its finally here!! (Yes, yet another build thread...) on 05-01-2015 at 04:56 AM
    I made some upgrades. I finally added a HLT. I brewed my first batch last weekend. My
    efficiency was extremely low. I think perhaps i sparged to quickly. I still have a few things
    to work out i suppos...

  • Posted in thread: Need some help troubleshooting my 50A GFI breaker... on 04-24-2015 at 01:21 PM
    Ok thanks. So from an education standpoint...why does a standard breaker not trip in this
    situation? Because the gfi is built to detect such a small amount of current between the two
    and standard brea...

  • Posted in thread: Need some help troubleshooting my 50A GFI breaker... on 04-20-2015 at 10:59 PM
    You need to be looking for a short or low resistance between ground and neutral.

  • Posted in thread: Need some help troubleshooting my 50A GFI breaker... on 04-20-2015 at 02:59 PM
    if neutral and ground are bonded anywhere down stream of your GFCI this will cause it to trip.
    A GFCI essentially trips when there is a difference in current between the hot legs and
    neutral. Also, us...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS