Last Activity:02-03-2016 7:52 PM
Likes Given: 13
39 Likes on 26 Posts
Posted in thread: Inexpensive way to get into a 20lb CO2 tanks on 12-30-2015 at 05:58 PM
I'm the originator of this post. When I took my empty tank back to Pepsi to refill they said
they couldn't give tanks to non-accounts anymore. The did give back the deposit. Think I had
found a one ti...
Posted in thread: Hi from Montana/South Korea. on 04-15-2015 at 05:16 PM
Welcome from the barley growing center of Montana. Would love to hear more about your malting.
Posted in thread: Montana Roll Call on 10-24-2014 at 04:23 AM
Ryan from Vaughn. GO CATS
Posted in thread: Show us your Kegerator on 10-20-2014 at 03:53 AM
Posted in thread: Central Montana Homebrew Club - Great Falls, MT on 09-04-2014 at 01:18 AM
Would love a club although life usually gets in the way and meetings are hard to attend. I bet
we could talk Bowser into letting us meet there. On second thought not sure if I can be in a
club with a ...
Posted in thread: McMaster Keg O-Ring List on 05-23-2014 at 04:43 AM
Well, just found a leak in my gas line from a slightly cocked gas QD with a poor-fitting
o-ring. Is the general consensus for pin lock QDs to use the silicon 10mm x 16mm x 3mm o-ring?
Has anyone tried...
Posted in thread: 100% homegrown on 05-04-2014 at 12:02 AM
I don't have access to any other fields. :(If you can get to Montana I lend you as many acres
as you want.
Posted in thread: Calling Accuflex Bev-Seal Ultra (3/16) experts on 03-18-2014 at 11:17 PM
Tried the Swaging tool and it worked very well. Put it in a vice and pointed a heat gun at the
tool. [ame] Swaging Tool
Posted in thread: Calling Accuflex Bev-Seal Ultra (3/16) experts on 03-01-2014 at 07:45 PM
Just ordered one of these. Will see how it works.
Posted in thread: McMaster Keg O-Ring List on 02-22-2014 at 04:48 AM
Thanks for the info.For both the pin lock gas and beer posts I have been using the 10mm (ID) X
16mm (OD) X 3mm (W) for over a year. They work great.