Last Activity:03-01-2012 3:18 AM
Posted in thread: WYeast 1187 Ringwood Ale on 10-27-2009 at 12:26 AM
Did a stout, OG 1.049, been in primary for 14 days, oxygenated with pure oxygen. Had several
days (2 or 3) a bit to cold 60 or so when I was gone for the weekend. The rest of the time it
has been at 6...
Posted in thread: Explosive pours on 10-08-2009 at 02:45 PM
The evidence seems to suggest the beer is over-carbed and the somewhat warmer lines and taps
are not helping at all. I would let the beer warm up some and bleed off some pressure until you
get no foam...
Posted in thread: Explosive pours on 10-08-2009 at 01:59 AM
OK, Keg air temp sensor is at 46, the poured beer is at 50, I do have a few air bubbles in the
lines, maybe 10% of the line. I'm at a loss.
Posted in thread: Explosive pours on 10-06-2009 at 01:41 PM
Ok sorry, the keg freezing incident was months ago, the fan fixed that. The frozen kegs are
long since drank. :cross: I'm going to take a temp reading of the beer itself when I get home.
I'm thinking ...
Posted in thread: Explosive pours on 10-06-2009 at 12:34 PM
OK, all great suggestions, but I do have a computer fan in the keg fridge hooked to an old cell
phone DC adapter that runs all the time. The reason I put it in is because I was freezing kegs
Posted in thread: Explosive pours on 10-06-2009 at 06:09 AM
OK, I have a chest freezer and I keep it at 40 to 42 and 11-13 psi. I had 6' lines and I
thought that was the problem. I got some new 12' lines, no good. The problem is that when I
don't have a beer f...
Posted in thread: Stainless shanks, worth it? on 09-30-2009 at 02:13 AM
Yea I need to get some of the BLC. I think I will go with the SS ones unless someone can tell
me why they are not worth the money. E
Posted in thread: Stainless shanks, worth it? on 09-30-2009 at 01:54 AM
I already have Perlick taps, and you are right they are worth the extra bucks. My question is
specifically about the SS shanks.
Posted in thread: Stainless shanks, worth it? on 09-30-2009 at 12:26 AM
Took a few of my Perlick taps off to clean, and my shanks looked nasty, almost rusted or just
discolored. I'm thinking of upgrading to all stainless shanks. The shanks I have are of unknown
origin. I ...
Posted in thread: co2 gasket on 08-29-2009 at 04:12 AM
Can you find something like this at a hardware store, or will I have to get it at the gas
supply place. Reason I ask is I would like one tomorrow, but not sure if any of the gas places