Erik53

Gift Premium Subscription To Erik53

Join Date:

01-10-2009

Last Activity:

11-11-2013 3:47 PM

    ABOUT ME

  • lubbock, tx
  • I just started brewing in Jan 2009.
  • Empty
  • NB's Imperial Stout
  • Apfelwein
  • NB's ESB
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: 60qt. Ice Cube Mash Tun Build - $cheap and simple on 12-13-2010 at 06:50 PM
    If it is your first ag batch, I would estimate a lower efficiency just to give you room for
    mistakes. I think that 75% is very possible once you have some experience under your belt with
    AG, but its e...

  • Posted in thread: 60qt. Ice Cube Mash Tun Build - $cheap and simple on 11-28-2010 at 01:54 PM
    Does anyone know if you can buy extra washers from the cooler side that has a ridge that seats
    the rubber grommet? Mine cracked when tightened down, apparently i'm stronger than I thought I
    was.I woul...

  • Posted in thread: Left keg in hot garage, now it is sour? (but sour in a good way) on 09-25-2010 at 08:23 PM
    I brewed a 10-gallon batch of pilsner in June. We drank all but half a kegs worth in August. I
    rotated the beers on tap and set aside the keg to let if lager a little bit more. Well, I ended
    up needin...

  • Posted in thread: 60qt. Ice Cube Mash Tun Build - $cheap and simple on 09-10-2010 at 08:43 PM
    The largest batch I have brewed in this setup was 10 gallons of IPA using about 25 pounds of
    grain. I had plenty of room in the cooler left.

  • Posted in thread: Deep Six Brewing System - v3.0 on 05-10-2010 at 05:39 PM
    I forget to mention that I took a picture. Here it is. Do you think its the same keg?

  • Added a new Photo on 05/10/2010

  • Posted in thread: Deep Six Brewing System - v3.0 on 05-10-2010 at 02:22 AM
    I saw one of those large kegs the other day when I was sitting in a McDonald's drive-thru. It
    was in the back of a McDonald's semi-truck with a long hose running from the keg to the inside
    of the rest...

  • Posted in thread: 60qt. Ice Cube Mash Tun Build - $cheap and simple on 04-20-2010 at 03:58 AM
    Looks good BigJason! In response to Bobby_M, I also preheat my mash tun substantially hotter
    than required for strike. After a few minutes I'll stir up the water and check the temp to see
    how close it...

  • Posted in thread: Counter Flow Chiller -$50 shipped - Bobbym's design on 03-18-2010 at 09:26 PM
    I made two of these when building one for myself since it is so much cheaper to purchase the
    3/8" copper tubing in 50' sections. I use one and I am selling the other. I have used the other
    one to cool...

  • Added a new Photo on 03/18/2010

0 COMMENTS
POST A COMMENT