VIEW MY

epcgordy

Gift Premium Subscription To epcgordy

Join Date:

09-15-2010

Last Activity:

05-25-2015 5:02 AM

1 Likes on 1 Posts 

    ABOUT ME

  • Seattle
  • Single

LATEST ACTIVITY

  • Posted in thread: Soldering Stainless steel on 03-27-2015 at 04:13 PM
    The last one I did did the same thing. I just used a hammer & chisel to tap the split as tight
    as I could get it to the coupling. Then I used a little plumber's putty to seal around the
    dimple, and th...

  • Posted in thread: My Single PID, Two Element Build on 09-06-2012 at 02:34 PM
    I found the busbars (terminal strips) at home depot. You can find them at McMaster and other
    online sources as well.

  • Posted in thread: My Single PID, Two Element Build on 09-05-2012 at 10:06 PM
    PM me your email address, and I'll send the full size file.:mug:

  • Posted in thread: My Single PID, Two Element Build on 09-05-2012 at 05:36 PM
    Here is the wiring diagram I used. It's based on one of PJ's diagrams, and modified to suit my
    preferences. I don't have a parts list, but used commonly available parts. The timer and PID
    are from Aub...

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 06-02-2012 at 04:26 PM
    Are you using the stock rubber gasket in this setup? Or just the o-ring and washer?Also, where
    did you get the washer? Did you find it locally, or did you have to order it?Thanks!That part
    of the setu...

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 02-14-2012 at 05:43 PM
    Epcgordy,Those solder connections look good. Quick question, based on some of the other posts
    in this thread - the straight threads of the heating element fit the tapered threads of the
    coupling witho...

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 02-13-2012 at 11:19 PM
    Thanks for the tip. Pretty self explanatory, but got a pic of it?Got a few pix last night. The
    first one shows the type of CPVC pipe to male pipe thread adapter that I pressed into the
    tapered stainle...

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 02-12-2012 at 04:08 AM
    Thanks for the tip. Pretty self explanatory, but got a pic of it?I get a shot or two posted in
    the next day or two.

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 02-12-2012 at 03:57 AM
    epcgordy. What size hole did you make for the coupling? 1-1/4? I did the same thing regarding
    the dimpling tool, I got a 1"-1-1/4" SS weld reducer and a 2" Black steel coupler. But I have
    not made the...

  • Posted in thread: Soldering a heating element mount - Hex vs. Coupling on 02-11-2012 at 01:00 AM
    SmokingDog,Yeah, I dimpled from the outside in. Mainly just because I preferred to do the
    soldering on the outside, where I could see what what the solder was doing as I was going.One
    cool thing I dis...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS