epateddy

Gift Premium Subscription To epateddy

Join Date:

08-20-2011

Last Activity:

09-04-2016 8:19 PM

5 Likes on 4 Posts 

    ABOUT ME

  • Male
  • Married
  • whitman
  • ma

LATEST ACTIVITY

  • Posted in thread: Double/Imperial IPA feedback on 02-27-2016 at 04:19 AM
    Great feedback, folks. Much appreciated.m00ps - I agree there are a lot of posters having this
    same issue. Could it be we're all following a traditional IPA recipe and just amping up the
    grains and ho...

  • Posted in thread: Double/Imperial IPA feedback on 02-25-2016 at 05:25 PM
    Worth a shot I guess. Will likely do this one again without the C90 and see what I get. What's
    that saying? Only change one thing at at time?

  • Posted in thread: Double/Imperial IPA feedback on 02-25-2016 at 02:52 AM
    I'm on round 2 of this one and the results are still very sweet. And the hop aroma/flavor is
    (surprisingly) just not there. Possibly drowned out by the sweetness. Interested in group
    feedback.13 lbs 2...

  • Posted in thread: CIP System on 05-12-2015 at 06:36 PM
    Is this pump still working well for you? We're looking at getting the same thing. Sump pump is
    not generating enough pressure to spin the ball effectively. What are you running through it?
    Hot water? ...

  • Posted in thread: Crankandstein 328D jam on 05-06-2015 at 02:08 AM
    Thanks for all the responses and ideas.I tried mounting the motor on a separate board on
    hinges, so gravity would pull the mill towards the table and tighten the belt via the weight of
    the motor. But ...

  • Posted in thread: Motorized Grain Mill Belt Tension Device on 05-01-2015 at 02:52 AM
    Think I'm running into a similar problem. Minimal grain causes my 328D to jam but the motor
    keeps spinning. Possibly not enough tension on the motor sheave. Is that just a basic caster on
    yours? That ...

  • Posted in thread: Crankandstein 328D jam on 05-01-2015 at 02:19 AM
    Hey all.Went big on my mill and got the 328D. Picked up a 1 HP 1725 rpm motor off of ebay, and
    1.5" and 10" sheaves to turn a v-belt. Planned on dropping 25 lbs of grain at a time into the
    hopper, but...

  • Added a new Photo on 05/01/2015

  • Posted in thread: Saison thoughts/feedback on 03-23-2015 at 07:14 PM
    Appreciate the additional suggestions. Would be interesting to try this one again and apply no
    additional heat above, say, 65 - allowing for that free rise.I may not be describing the
    "tartness" corre...

  • Posted in thread: Saison thoughts/feedback on 03-19-2015 at 03:31 PM
    Thanks for the thoughts/replies.Quaker - I pitched around room temp (68), placed it in the
    insulated ferm chamber and set the heat wrap to 80. So it did warm up, probably quickly. I'm a
    big fan of Sor...

0 COMMENTS
POST A COMMENT