Last Activity:05-21-2015 6:46 PM
Likes Given: 1
9 Likes on 7 Posts
Posted in thread: Wiring questions on 06-12-2015 at 02:42 AM
I ran line 1 through it. But I don't have my elements ready yet, so it hasn't been under a load
yet and I have no idea if it works.
Posted in thread: Found a new use for my ferm chamber controller on 05-21-2015 at 06:39 PM
This litter was 7 males and 5 females. We're keeping one of the boys for ourselves
Posted in thread: Found a new use for my ferm chamber controller on 05-21-2015 at 01:27 AM
Yep, at warmer temps
Posted in thread: Found a new use for my ferm chamber controller on 05-20-2015 at 08:54 PM
279382Powering a heat lamp for our new puppies
Posted in thread: Wiring questions on 05-07-2015 at 03:39 PM
That makes sense for the grounds. So it would be 10ga wire, since the largest individual load
is a 5500 watt element. With the home run wiring, the highest load it could possibly see is 23
amps. I hav...
Posted in thread: Wiring questions on 05-07-2015 at 03:47 AM
I'm building a 50A back-to-back eHERMS panel, with parts from ebrewsupply.com among others. I
have two questions for you electrical gurus. 1. What gauge wire do I need for the grounds? The
Posted in thread: Almost done on 05-02-2015 at 04:27 AM
Pretty exciting week for me, I just made the last big orders for my eHERMS control panel. It's
a pretty standard Kal clone, with parts from ebrewsupply.com. 50 amps, so I can do back-to-back
Posted in thread: HERMs coil question on 02-23-2015 at 10:04 PM
Wish I had seen that before I built mine
Posted in thread: Methods to achieve accurate temp readings? on 02-20-2015 at 12:29 AM
I was actually gonna post a question on the same topic. Kal's system uses a pump to cycle the
HLT water, and the output temp of the HLT fires the HLT heating element. I was curious whether
you'd get t...
Posted in thread: Chugger pumps on 12-16-2014 at 01:36 AM
I turn the pump off as soon as it starts to cavitate. You can tell by the sound.