Last Activity:07-03-2012 12:22 AM
Likes Given: 1
1 Likes on 1 Posts
Posted in thread: You asked for it! on 05-08-2012 at 07:06 PM
Awesome! I know that there are many automated systems (both electric, gas, and or steam) that
can be much better categorized here! Thanks TX.
Posted in thread: The Beer Robot: BCS-462, Single Tier, eHERMS, two pumps on 02-13-2012 at 05:50 AM
Nice job on the enclosure, looks brand new.
Posted in thread: Temp sensor fluctuation on 03-14-2011 at 04:30 PM
does anyone know if any of those models correspond to the one's Brewer's Hardware sells?No,
that's just a calculator that we hijacked from another company. We should really get our own.
It just solves...
Posted in thread: Temp sensor fluctuation on 03-13-2011 at 03:53 PM
I was referring to post #15 display of the sensor readings where it appears that the samples
were taken on 3 second intervals and there was noticeable fluctuation in the readings where
there should no...
Posted in thread: Temp sensor fluctuation on 03-13-2011 at 05:01 AM
Sounds like a bit of engineering is needed for this platform with wandering sensor readings and
noise sensitivity problems that need addressed.Not sure what you're referring to. I think we've
Posted in thread: Temp sensor fluctuation on 03-12-2011 at 05:08 PM
Yes, the last screen shot looks much better. Varying a few tenths is pretty normal and well
within spec of these probes, particularly when they're not submersed. You might have to
calibrate them to re...
Posted in thread: Temp sensor fluctuation on 03-11-2011 at 01:36 PM
Did you update the temperature probe settings for the Brewers Hardware probes? The BCS ships w/
coefficients that match our probes, the BH probes have their own set. If you try to use
settings that do...
Posted in thread: New Brewery Build on 02-25-2011 at 02:00 PM
Bulk malt... not too much ;)Wow, that is some serious grain. Your stocks would make many LHBS's
Posted in thread: BCS user control panel question on 02-19-2011 at 02:00 AM
Those relay boards have built in transistor drivers to handle that 70ma relay coils. They only
require about 50uA (micro amps) of current from the BCS, so well within budget. Since the +5VDC
pin of th...
Posted in thread: BCS user control panel question on 02-19-2011 at 01:26 AM
Yes, higher processes take priority. However its not recommended to have two processes drive
the same output.Here's a relay that is compatible with the BCS. They also make 12v cards,
however that woul...
- Bottling Rant
- WSM size?
- Adding yeast prior to bottling
- 45-minute mash not enough for conversion at 156F?
- Candida (yeast overgrowth) internally - men are not suppose to look pregnant.
- What are you drinking now?
- Beer Emergency--deploying for 7 months in less than 5 days
- Things a Homebrewer Thinks
- BIAB vs mash tun
- Distilling - need info
- What's the worst craft brew (commercial) you've had?