Last Activity:07-31-2014 5:26 AM
7 Likes on 6 Posts
Posted in thread: Long lag time on 07-30-2014 at 10:55 AM
It's a 4.7% rye pale ale. So I get the dry rye mild spice character in the malt profile. Good
hop character from Amarillo and cascade. One thing that I feel it may lack is a little more
body. I'm not ...
Posted in thread: Long lag time on 07-29-2014 at 12:38 PM
So after all the worry the beer finished out at 1.012. Super happy with that. It does not have
any off flavors according to my palate, I'm not saying it's a great palate either. Thanks for
all the hel...
Posted in thread: Long lag time on 07-15-2014 at 05:50 PM
Just a side note for you guys. I was instructed by a pro brewer to hit it with pure o2 and that
I could get away with that until about 50% of the way through fermentation without noticing any
of it in...
Posted in thread: Long lag time on 07-15-2014 at 04:21 PM
It's a session rye pale ale and I used WLP001. I'm moderately confident in the amount of yeast
pitched it's just the long lag time that I never had to deal with. When it did start up it was
just as vi...
Posted in thread: Long lag time on 07-15-2014 at 03:23 PM
Here's my issue. I brewed a 1.048 OG beer and pitched 100ml of 6 day old washed yeast. Did not
make a starter ( first mistake I know ). It took just over 2.5 days to start but after dosing
Posted in thread: IPA Pickles?!? on 08-26-2013 at 10:19 PM
We finally have a few cucumbers in our garden, so I decided to make a very small batch of Hoppy
Pickles myself!Since I'm only doing two pints to start, these are refrigerator pickles so there
will be ...
Posted in thread: Tubing size for 1/4" MPT threads on 08-23-2013 at 06:57 PM
quick question - what size tubing will fit over 1/4" mpt threads?(i tried searching, but
couldn't find a readily available answer)1/4" fpt
Posted in thread: Draught tower question on 08-14-2013 at 01:54 PM
I had a single tap and added two more taps to my tower. All I did was offset the two additional
holes a little lower and they fit perfectly. I picked up the collar piece that attaches to the
Posted in thread: Draught tower question on 08-14-2013 at 02:37 AM
It'll prob depend on the diameter of ur current tap. If its less then a 2 tower tap system u
prob won't be able to mount them level without the shanks touching each other. a perfect
example of this ar...
Posted in thread: Draught tower question on 08-14-2013 at 01:06 AM
The single tap towers tend to be 2.5" IIRC and the double tap towers are usually 3" to fit the
extra line and shank in there. Have you seen one of these?: might be what you are in the