Last Activity:07-11-2016 12:46 PM
2 Likes on 2 Posts
Posted in thread: False Bottom BK Bottom Drain Keggle? on 04-11-2016 at 10:39 AM
I purchased the false bottom and stand and it does not fit for an upside down bottom drain keg.
There is a significant gap between the stand and the false bottom.
Posted in thread: PC Case Control Panel Build on 11-02-2015 at 03:30 PM
I am using this old schematic by P-J. I want to add a second PID for monitoring mash temps.
Also the element select switch is LED, and the main PID power switch is LED as well so I need
to wire them a...
Posted in thread: PC Case Control Panel Build on 11-02-2015 at 03:23 PM
Did some work on the panel last week. I was impatient waiting for the paint to dry so I need to
scrape off some newspaper on the bottom. I am going to wire in the inside tomorrow.
Posted in thread: PC Case Control Panel Build on 10-21-2015 at 05:58 PM
It swings open ok. The hinged end is grooved so when the case was closed it fit snug in there.
The only time its tough is when you go to close the door. It has a little hiccup when the
groove locks in...
Posted in thread: PC Case Control Panel Build on 10-21-2015 at 05:23 PM
Added the hinges today and cut the sheet metal to cover the openings. The door doesnt swing
open that smoothly, but it wasn't designed to be hinged.
Posted in thread: FS beverage air dd68 kegerator nyc on 10-21-2015 at 02:42 PM
necro bump but this is still available for sale
Posted in thread: PC Case Control Panel Build on 10-20-2015 at 04:25 PM
So I found the wiring diagram that was made by P-J. We used this for our original control panel
build. I want to make some slight alterations to it now. The switches for the 2 pumps, element
Posted in thread: PC Case Control Panel Build on 10-19-2015 at 08:57 PM
So I was cleaning out my garage and I found an old Alienware PC case. It's about time we
upgraded our existing control panel, so I figured this might work for the new box. Anyone have
built something ...
Posted in thread: Kill-A-Watt Brewery Build Compilation on 12-03-2014 at 02:39 PM
Could a similar build work without the RIMS, and instead using the HEX in the HLT/BK as a
HERMS? Dough in the MT then heat HLT to mash temps. Recirc the mash through the HEX in the HLT,
once mash is f...
Posted in thread: DIY Beer Line Cleaner on 03-28-2014 at 01:16 PM
Does anyone know what size flare fitting fits on the firestone gas post? Thanks