Gift Premium Subscription To DRog00

Join Date:


Last Activity:

01-05-2017 6:50 AM

3 Likes on 3 Posts 


  • Mr DR12
  • Female
  • Single
  • Houston
  • Tx


  • Posted in thread: Crankandstein 328D jam on 05-07-2015 at 05:21 AM
    When I say cam, make sure that your bottom roller is set to the same setting on both sides. I
    have a monster mill, so they don't have the detents like the CM does. Make sure your end caps
    are square, ...

  • Posted in thread: Crankandstein 328D jam on 05-01-2015 at 04:49 AM
    A local homebrew shop bought one and I fitted it to a stand. It would work perfectly for a few
    runs, then jam. It was embarrassing. Things to check:Your end plates are mounted square with
    each other.T...

  • Posted in thread: List of PJ Electrical Diagrams on 01-16-2015 at 08:03 PM
    Is there a way to get the bare images of the components used to make these diagrams? I want to
    make my own diagram using P-J's as a base. Thanks!

  • Posted in thread: Equipment Storage in the South on 12-03-2014 at 04:58 AM
    My brew system sits outside, year round, granted it is all steel, stainless. If you've got
    plastic, it'll get brittle with heat cycles, and sun exposure, but humidity won't really affect
    it unless you...

  • Posted in thread: Regulator for commercial oxygen tanks? on 10-13-2014 at 07:07 PM
    I have one of these and it works great. I got a full O2 bottle at a local welding shop for $65,
    and I bet I've used less than 5% of it over the last 30 brews.

  • Posted in thread: garage sale houston/katy on 09-23-2014 at 10:05 PM
    Check your messages sir.

  • Posted in thread: 6" hole on 03-07-2014 at 09:51 PM
    I agree, get a real hole saw. It might take longer and be more expensive but it will make a
    near perfect circle through the sill plate.

  • Posted in thread: How do you keep pipettes clean and sanitized? on 11-26-2013 at 08:52 PM
    Buy new ones..

  • Posted in thread: SS 1/2" NPT needle valves? on 09-16-2013 at 04:38 AM
    I wouldn't worry about it, honestly. After you get used to ball valves, you can adjust your
    flow with small adjustments. My system has a 3qt gravity fed grant that the pump pulls from. I
    can adjust th...

  • Posted in thread: Video test of Sabco Plate Pro heat exchanger on 07-27-2013 at 05:03 AM
    By the time you take that thing apart, and reassemble it, you'll be out 3-4 hours of your day,
    and, you'll be lucky if it doesn't leak once you are done. Better order a new set of gaskets
    now before y...

Following Stats