VIEW MY

Drifter

Gift Premium Subscription To Drifter

Join Date:

01-07-2009

Last Activity:

09-26-2009 5:12 PM

    ABOUT ME

  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: First AG (ended up not so AG) on 08-02-2009 at 12:06 PM
    How long did it take you to sparge??

  • Posted in thread: Copper IC Question on 07-21-2009 at 12:36 AM
    I made a 3/8" copper IC, the copper is not the bright shiny stuff one normally sees. What is
    the proper procedure to clean the copper and make it shiny???

  • Posted in thread: Efficiency Problem on 06-22-2009 at 11:10 AM
    I left that out, I did do a 168 deg mash out prior to sparging. I do use a sparge arm (non
    rotating) I also use a T-Bazooka for the seperator. And as far as the crush it has been done at
    my LHBS not t...

  • Posted in thread: Efficiency Problem on 06-22-2009 at 12:39 AM
    4th AG batch learned alot from the first 3. All of them had horrible efficiencies. I am able to
    explain them all and again I learned from the mistakes. My 4th went very well, 1 hour mash at
    155. 173 d...

  • Posted in thread: New to AG brewing on 06-15-2009 at 11:58 AM
    I did my third AG batch this past weekend. The first was a unmitigated disaster. The second
    went much better and the third went pretty good. My question is this. When you use 170 deg F
    sparge water wh...

  • Posted in thread: What do you think this is? Yellow on the outside of leaf on 06-09-2009 at 01:15 PM
    I have 8 plants all first years and this has happened to the 2 Fuggle plants. I have checked
    the pH and it is within normal ranges. I dug down into the soil of these two particular plants
    and they wer...

  • Posted in thread: Hop Dryer Plans? on 06-02-2009 at 02:32 PM
    Is it possible to use a run of the mill food dehydrator to dry the hops

  • Posted in thread: DIY Sight Gauge on 03-23-2009 at 06:21 PM
    I have used polycarbonate tubing from McMaster p/n 9176T28 it is $10.08 for an 8' piece. I use
    a 90 deg compression fitting and run the tube(cut to length) to the top. I use a s.s. eye bolt
    to hold it...

  • Posted in thread: Culturing Yeast on 01-28-2009 at 02:22 PM
    I have successfully created slants and grew the colonies and pitched them. Here's my question I
    made 6 slants from an original WYeast slap -pack. Now I am down to one slant, what is the
    proper way to ...

  • Posted in thread: Automated Gas Valves on 01-26-2009 at 11:06 PM
    I am looking into using furnace valves for controlling temperature on my HLT and brew kettle. I
    have the temperature controllers and T/C'sCould some one recommend a pilot valve to use with
    the system....

0 COMMENTS
POST A COMMENT