VIEW MY

DrDirt

Gift Premium Subscription To DrDirt

Join Date:

11-24-2009

Last Activity:

01-23-2014 6:31 PM

Likes Given: 1

3 Likes on 3 Posts 

    ABOUT ME

  • Georgia
  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: Conical fittings on 07-18-2013 at 01:41 AM
    Scratch that. The reducer is 2" female to 3/4 inch female. I added a barb in between that and
    the valve.

  • Posted in thread: Conical fittings on 07-18-2013 at 01:39 AM
    I cant remember for sure, but I think I got all the additional parts from Ace hardware locally.
    The 2" male to 3/4 inch female reducer shouldn't be too hard to find. I added the pipe clamp
    around the ...

  • Posted in thread: Conical fittings on 07-17-2013 at 11:23 PM
    Here's a photo of my setup. For reference, the crossmember on the stand is just above the 1
    gallon line.

  • Posted in thread: Conical fittings on 07-17-2013 at 11:15 PM
    I usually do 20 or 25 gallon batches. With the dump/collect/dump schedule I suggested above
    I've never had the trub collect much higher than about a half gallon (about 4-5 inches up the
    cone). I've ne...

  • Posted in thread: Conical fittings on 07-17-2013 at 12:41 AM
    Your setup is very close to what I have, same stand, it appears.My racking port is about 6-8
    inches up from the base of the cone, slightly below the 1-gallon line (at about the 3/4 gallon
    area). I don...

  • Posted in thread: Conical fittings on 07-16-2013 at 10:50 PM
    Mine's mounted vertically (the fermenter sits in the basement bathroom, directly above a
    drain). The racking port is at about 45 degrees but I generally try to dump or collect before
    the trub reaches ...

  • Posted in thread: Conical fittings on 07-15-2013 at 10:45 PM
    I have a 30 gallon with a 3/4 inch dump at the bottom, occasionally it takes a minute to begin
    flowing, but I've never had it clog up entirely. I think you'd be okay going to 1/2 inch.

  • Posted in thread: Upgrading to 20 gallons batches - advice please on 07-11-2013 at 10:45 PM
    When I moved from 10 to 25 gallon batches I quickly realized that cleaning and sanitizing five
    carboys was a royal pain in the A. Also, racking to kegs too forever. The best purchase I made
    was a 30 g...

  • Posted in thread: Knock-out punch for 3mm stainless on 07-09-2013 at 11:01 PM
    How big a hole are we talking? Couldn't you just use a step bit and a drill?

  • Posted in thread: HDPE conical - to bleach or not to bleach? on 07-05-2013 at 03:13 PM
    Thanks for the suggestions guys. 30 gallons of boiling water is going to be a tall order, but
    I'm going to give it a go with hot tap water and bleach.

FORUM SIGNATURE
Quote: Originally Posted by Robsbrew View Post Awesome man. I think that was the most helpfull post Ive gotten so far. Thank you!
0 COMMENTS
POST A COMMENT