Drake9

LATEST ACTIVITY

• Posted in thread: eBIAB New Guy on 05-15-2013 at 05:04 PM
  So after further research I have come up with the following plan. Use one of the existing
  keggles, sell MLT and keggle to help fund this. I have come up with the following parts list
  which is pretty c...

• Posted in thread: Greenlee knouckout punch kit for element and ball valve on 05-14-2013 at 07:08 AM
  I used a punch for several holes on my keggles with no real issues. You will not be able to use
  the same punch for the element and the weldless ball valve either. The weldless ball vale needs
  a 7/8" h...

• Posted in thread: eBIAB controller & pump, in a toolbox - questions on 05-10-2013 at 06:06 AM
  Did you get this build done? Would like to see completed pictures of the inside if you have
  them. I am thinking about using a toolbox for the enclosure and not understanding what you are
  talking about...

• Posted in thread: Pictures of first brew day with eBIAB on 05-04-2013 at 08:04 AM
  Hey Jake,I am very happy I made the switch. The ease of the brew day really lets me focus on
  producing the best possible beer without worrying about my system. I set the mash temp and then
  an alarm so...

• Posted in thread: Pictures of first brew day with eBIAB on 05-03-2013 at 06:27 AM
  While this was my first eBIAB I got 72% brew house efficiency. I was averaging around 75%
  before with a traditional sparge and separate vessels. The very slight decrease is an easy
  price for me to pay...

• Posted in thread: BIAB... plus? on 05-02-2013 at 04:01 AM
  I might have to try this. I think I am going to build a eBIAB keggle and this might be the
  answer to my basketand hoist question for the setup.

• Posted in thread: Enclosure on 05-01-2013 at 12:18 AM
  If OP doesnt want it I will take it Toymaker.

• Posted in thread: eBIAB New Guy on 04-30-2013 at 06:43 AM
  I was in the process of building a 3 vessel propane system and have decided I might want to go
  a different direction. The reason is I really want to go electric and like BIAB to keep cost
  down a littl...

• Posted in thread: Problem building DIY stirplate (CPU fan and cell phone chargers) on 04-24-2013 at 06:44 PM
  What is the voltage on the cell charger? I had a similar problem and that is what the issue
  was. I ended up getting a adujastable one from Radio Shack. That was driven by the fact I could
  not dial my ...

• Posted in thread: Welding Brutus Ten on 04-19-2013 at 06:31 PM
  From my limit knowledge there is a flux core for stainless but it is very expensive. In my
  opinion you would be better off finding a used Miller or Lincoln machine and getting the tri
  gas. It really d...