Gift Premium Subscription To dplin2001

Join Date:


Last Activity:

02-12-2014 6:59 PM


  • Posted in thread: Large Giveaway - Fermenter, Mash Paddles, Thermapen on 11-30-2010 at 06:19 AM
    username: dplin2001

  • Posted in thread: Brutus Ten ???? on 11-20-2007 at 01:40 AM
    Oh no dplin2001! No offense at all! In fact, I have been putting a dedication page together for
    my website for a while now. I have about 20 other Brutus 10's that others have built. I stole
    your pictu...

  • Posted in thread: Brutus Ten ???? on 11-20-2007 at 12:48 AM
    First, let me address the few disgruntled… :) Really fellas, some may think that I gave BYO
    these prints to Brutus Ten. This is not the case. They were a BIG customer just like you! So I
    know that you...

  • Posted in thread: Brutus Ten ???? on 11-20-2007 at 12:16 AM
    He says he used SC8210G37 valves....Not sure why they would say that; from their site: just
    don't get why direct fire the mash, when the MLT is there to provide a heat source for a coil
    to recirculat...

  • Posted in thread: Brutus Ten ???? on 11-19-2007 at 04:38 AM
    I too bought the plans and then it comes out in BYO, oh well. The price of stainless has more
    than trippled in price from what is listed. Also the ASCO vavle he used will work, but was not
    made for ga...

  • Posted in thread: Plate Chiller on 10-10-2007 at 04:32 PM
    Keep us posted on your progress.

  • Posted in thread: Stir Plate Help on 09-02-2007 at 10:01 PM
    I couldn't get mine to work very well at all with multiple magnets at opposite sides of the
    fan. The stir bar keeps latching onto one of the two magnets and swinging around like a lasso,
    which makes i...

  • Posted in thread: Stir Plate Help on 09-02-2007 at 09:38 PM
    How about just using one of the selectable power supplies? I built the stir plate and it didn't
    work for some reason. So I just wired up an adjustable power supply through a switch and put it
    in a pro...

  • Posted in thread: help me understand propane burners, and check some out... on 05-17-2007 at 07:23 PM
    I've been looking into burners too and here is what I found out.The BG10, BG12, and BG14
    burners with;10psi regulator will give you 65k BTU15psi regulator will give you 120k BTU20psi
    regulator will gi...

  • Posted in thread: Mash Monitor on 04-05-2007 at 05:49 AM
    Are you guys going to have your program do a step mash and control all the valves and burners?
    I found this forum because I have been think of doing the same thing, you guys are much farther
    ahead of ...