doogie3484

Gift Premium Subscription To doogie3484

Join Date:

03-10-2010

Last Activity:

04-20-2014 10:19 PM

    ABOUT ME

  • Engineering
  • Aksel Hauser
  • Lemon Weiss
    Pumkin Ale
  • English Strong Ale
    Milk Stout
  • Male
  • Married
  • Zimmerman
  • MN - Minnesota

LATEST ACTIVITY

  • Posted in thread: Construction Forum on 02-23-2012 at 07:01 PM
    I think Moto is redundant.and with the DIY thread... I think the idea is also redundant.How
    about some sort of "semi pro/pro brewers" section? I know the site is "homebrewtalk" but it
    seems like every...

  • Posted in thread: Sankey to tri-clamp o-ring gasket? on 01-03-2012 at 04:14 PM
    Ok one other thought you could try sanding one of the Teflon gaskets down to your desired
    thicknessBrewers Hardware 1.5" Tri Clover Gasket PTFE

  • Posted in thread: Sankey to tri-clamp o-ring gasket? on 01-03-2012 at 03:58 PM
    Couldn't you just trim the round part off of one side with a razer

  • Posted in thread: Kegs welded for $45!! on 12-30-2011 at 07:33 PM
    Let me know how they come back. I am looking for a welder and my parents live in Rochester so
    that would work great!!

  • Posted in thread: Larger coupling/valve for Keggle? on 11-09-2011 at 12:56 PM
    You can just flip the keg over and use a 2" tri clamp valve for a bottom dump on the stem if
    the keg, if you haven't already cut it that is.

  • Posted in thread: Bottled my first pumpkin ale yesterday - things I've learned on 10-10-2011 at 08:50 PM
    I just did an all grain pumpkin and had my first stuck mash. I will deff had rice hulls if you
    add it to the mash.

  • Posted in thread: Help designing my RIMS on 10-10-2011 at 02:55 PM
    Ok so I just needed to look a little longer. Found this on ebay I think this could work, I am
    just worried aout the amount of pressure it takes to open the valve. It doesn't say on this
    valve all the ...

  • Posted in thread: Help designing my RIMS on 10-10-2011 at 02:36 PM
    OP, you might want to make certain that the top of the heating element is kept below the level
    of the mash to avoid dry firing if the pump loses prime. The water level might fall to the
    height of the ...

  • Posted in thread: Help designing my RIMS on 10-06-2011 at 11:58 PM
    Ya I was starting to think that if I didn't have enough power to heat the ground water to temp.
    I could use the hot water from my water heater that already starts at ~130 so I would only have
    to heat ...

  • Posted in thread: Help designing my RIMS on 10-06-2011 at 10:43 PM
    No i didn't think of that, but I'm thinking I want to try and put a 5.5kw element in the rims
    tube so I would be able to have on demand hot water for my sparge. I would like to keep my
    system rather s...

0 COMMENTS
POST A COMMENT